579449
59
Zoom out
Zoom in
Vorherige Seite
1/62
Nächste Seite
TROUBLESHOOTING
58
Error Messages
Memory Full!
There is not enough internal memory available when you try to save
a label file. Delete any unnecessary files to make more memory
available for the new label file.
Check # of Digits
Entered!
The number of digits entered in the bar code data does not match the
number of digits set in the bar code parameters. Enter the correct
number of digits.
Input A,B,C or D At
Start&End!
The bar code data entered does not have the required start/stop
code (A, B, C, or D required at the beginning and end of the bar code
data for the CODABAR protocol). Enter the bar code data correctly.
Maximum Of 5 Bar
Codes Per Label!
There are already 5 bar codes entered in the text data when you try
to enter a new bar code. You can only use up to five bar codes in
each label.
Text Too Large!
The text size is too large. Select a different size option.
Select Other Cut
Option!
The tape length set using the tape length setting is shorter than the
total length of the left and right margins applied for the "Large
Margin" cut option. Select a different cut option.
Close Cover!
The rear cover is open. Close the cover when printing.
Installed tape is not
compatible with this
machine!
Tape that is incompatible with the P-touch labeler has been installed.
Use a compatible tape.
Category Full!
The memory available for categories is full. To make more memory
available, delete any unnecessary registered label files by
highlighting the label file and pressing the
OK
key.
Already Exists in
Favorites!
The label which already exists is added in favorites category of label
collection.
Favorite Folder
Empty!
Favorites folder of label collection is empty.
Insert Corresponding
Tape Cassette!
Either no tape cassette is installed, or a 0.47" (9 mm) width or
narrower tape cassette is installed when printing from the label
collection.
If a Heat Shrink Tube is installed, you are trying to print a label that
cannot be printed on Heat Shrink Tube.
Install an appropriate tape.
System Error 01!
Please contact our customer service.
Refer to the Quick Setup Guide for the contact information.
System Error 02!
Please contact our customer service.
Refer to the Quick Setup Guide for the contact information.
Message Cause/Remedy
59

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Brother P-Touch H500 LI wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Brother P-Touch H500 LI

Brother P-Touch H500 LI Bedienungsanleitung - Deutsch - 62 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info