718903
8
Zoom out
Zoom in
Vorherige Seite
1/75
Nächste Seite
Chapter 1
4
Removing the Rechargeable
Ni-MH Battery
1
a Open the battery cover by pressing the
cover latch.
b Swing the cover open and remove it.
c Gently pull the battery removal ribbon
until the rechargeable Ni-MH battery
starts to tilt out of its compartment.
1 Battery removal ribbon
NOTE
If the battery removal ribbon is trapped
behind the rechargeable Ni-MH battery,
insert a thin metal object such as a
flat-blade screwdriver between the battery
and the case at the end away from the
AC/DC connector, and tilt it out of its
compartment.
d Remove the rechargeable
Ni-MH battery from the compartment.
e Gently pull the rechargeable
Ni-MH battery connector and
disconnect it from the terminal inside
the printer.
Charging the Rechargeable
Ni-MH Battery 1
Perform the following procedure to charge
the rechargeable Ni-MH battery.
NOTE
Charge the rechargeable Ni-MH battery
immediately after purchase using the
following procedure.
Up to 120 minutes is needed to fully
charge a rechargeable Ni-MH battery.
About 70 pages can be printed when
using a new, fully-charged rechargeable
Ni-MH battery.
a Install the rechargeable Ni-MH battery
into the printer.
b Use the AC adapter and AC power cord
to connect the printer to an AC power
socket, or use the DC cable to connect
the printer to a DC power socket.
c Make sure that the printer is turned off.
d Press and hold the (Power) button for
a few seconds until the POWER
indicator begins to blink in green.
NOTE
Depending on the settings specified in the
PJ-673 Utility, charging of the rechargeable
Ni-MH battery may begin after the battery is
refreshed. For more information, see
Refresh Ni-MH Battery on page 46.
While the POWER indicator is blinking in
green and orange, the power remaining
in the rechargeable battery is being
discharged and the battery is being
refreshed (see Explaining Battery Terms
on page 5).
If there is still a considerable amount of
charge in the rechargeable Ni-MH battery,
it may not be refreshed.
While the rechargeable Ni-MH battery
is being refreshed, press and hold the
(Power) button to stop refreshing the
battery and begin charging it.
1
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Brother PJ-673 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Brother PJ-673

Brother PJ-673 Bedienungsanleitung - Deutsch - 76 seiten

Brother PJ-673 Bedienungsanleitung - Holländisch - 75 seiten

Brother PJ-673 Bedienungsanleitung - Französisch - 81 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info