GB - 23
b) Battery
Voltage: 15 x 1.2V Ni-Cd batteries
Charging period: 4 - 5 Std.
Capacity: 1,200 mAh
c) PSU
Primary: 230V/50 Hz AC
Secondary: 24V/400 mA DC
Charging the battery pack
• Charge the battery pack (4) before using the drill for the first time.
• Only charge the battery (4) at ambient temperatures of 10–40°C (50–104°F).
• Plug the PSU (8) into a 230V AC mains power supply only, and connect it to
the charger (7).
• Do not place anything else into the charger’s battery opening (7).
• Never attempt to dismantle the battery (4).
• Only use the charger supplied to charge the battery pack.
• To remove the battery pack (4) from the tool, push both clips (5) down and pull
the battery downwards out of the housing.
• Plug the battery pack (4) into the charger (7). Make sure that the plus (+) and
minus (-) poles are correctly oriented.
• Red and green LED will light once the battery has been inserted correctly.
• Only charge the battery for four to five hours. Overcharging the battery (longer
than eight hours) may damage the battery and/or charger.
• Remove the battery pack (4) from the charger (7) and push it into the cordless
screwdriver’s handgrip until you hear the clips (5) click into place.
LED display
The red LED shows the loading-station is ready for charging; the green LED
shows the loading-process of the battery-pack. The LED displays on the charger
(9) do not show
the charge status of the battery, and the charger does not switch
itself off once the battery is fully charged. Remove the battery from the charger
after four to five hours and unplug the charger from the mains.
