Bedienungsanleitung Bryant Legacy 106A (Seite 2 von 2) (Englisch)

628118

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Always Ask For

S Keep Filter Clean

A clogged or improperly installed air filter on your indoor unit will

increase operating costs and shorten the life of the unit. For

detailed filter cleaning information refer to indoor unit literature.

S Do Not Block Floor, Wall or Ceiling Vents

When drapes, furniture, toys or other common household items

block vents, the restricted airflow lessens the system’s efficiency

and life span.

S Do Not Cover or Block Outdoor Unit

The outdoor unit needs unrestricted airflow. Do not cover it or

place items on or next to it. Do not allow grass clippings, leaves, or

other debris to accumulate on the sides or top of the unit. And,

maintain a 12” (304.8 mm) minimum clearance between the

outdoor unit and tall grass, vines, shrubs, etc.

S Check Condensate Drain

Your air conditioner removes humidity from your home during the

cooling season. After a few minutes of operation, water should

trickle from the condensate drain of the indoor coil. Check this

occasionally to be sure the drain system is not clogged. Drainage

will be limited if you live in a very dry environment.

S Do Not Operate Below 55°F/12.78°C

Your outdoor unit is not designed to operate when outdoor

temperatures are lower than 55_F/12.78_C without modification.

If operation below this temperature is required, consult your Bryant

dealer.

S Coil Cleaning

Your indoor coil is located in a sealed cabinet on your indoor unit

and will require minimal cleaning with routine filter maintenance.

Longer operating cycles and reduced energy efficiency may

indicate the need for a coil cleaning by your Bryant dealer.

S Base Pan Drainage

Periodically check for and remove debris that has settled around

the base of your outdoor unit. This will ensure proper drainage of

the base pan and eliminate standing water inside the outdoor unit.

S Level Installation

Your Bryant dealer will install the outdoor unit in a level position.

If the support base settles or shifts and the unit is no longer level,

be sure to re--level it promptly to assure proper drainage. If you

notice water or ice collecting beneath the unit, arrange for it to be

drained away from the unit.

SEA COAST COIL MAINTENANCE

Coastal locations often require additional maintenance of the

outdoor unit due to highly corrosive airborne ocean salt. Although

your new Bryant system is made of galvanized metal and is

protected by top--grade paint, take the additional precaution of

periodically washing all exposed surfaces and the outdoor coil

approximately every 3 months. Consult your installing Bryant

dealer for proper cleaning intervals and procedures for your

geographic area or ask about a service contract for regularly

scheduled professional cleaning and inspections.

TROUBLESHOOTING

Before you request dealer service, check for these easily solved

problems:

S Check the indoor and outdoor disconnect switches Also check

your main electrical panel circuit breakers or fuses.

S Check for sufficient airflow. Air filter(s) should be reasonably

clean and interior vents should be open and unobstructed.

S Check thermostat settings. For cooling, your desired

temperature setting should be LOWER than the displayed

room temperature, and the System/Mode control should be on

Cool or Auto. For heating, your temperature setting should be

HIGHER than the displayed room temperature, and the

System/Mode control is set to Heat or Auto.

S Time delays - depending on the Bryant air conditioner you

have, there may be delays in unit operation that are built-in to

protect the equipment and your comfort. Don't be alarmed if

you notice a time delay in operation. It may be a standard

protection feature of your equipment. Check with your Bryant

Dealer for more information on time delays.

If you need to contact your Bryant dealer for troubleshooting

and/or repairs, be sure to have the model and serial numbers of

your equipment available (there are spaces on the cover for you to

write this information). With this information, your dealer may be

able to offer helpful suggestions over the phone or save valuable

time through knowledgeable preparation for the service call.

REGULAR DEALER MAINTENANCE

In addition to the routine maintenance that you perform, your

home comfort system should be inspected regularly by a properly

trained service technician. Many dealers offer this service at a

reduced rate with a service contract. Some service contracts offer

additional benefits such as parts discounts and no additional charge

for ”after hours” or emergency service.

Your annual system inspection should include:

S Routine inspection of air filter(s) with replacement or cleaning

as required

S Inspection and cleaning of the blower wheel housing and

motor

S Inspection and, if required, cleaning of indoor and outdoor

coils

S Inspection of the indoor coil drain pan, as well as the primary

and secondary drain lines. If the system has an auxiliary drain

pan and line, they should be inspected at this time as well.

Service should include cleaning if required.

S Check all electrical wiring and connections

S Check for secure physical connections of individual parts in

each unit

S Operational check of the air conditioning system to determine

actual working condition. Necessary repair and, or adjustment

should be performed at this time.

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

E2007 Bryant Heating & Cooling Systems D 7310 W. Morris St. D Indianapolis, IN 46231 Printed in U.S.A. Edition Date: 11/07

R e p l a c e s: O M 0 1 --- 2 4

Catalog No. OM01---25

Bryant Legacy 106A Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info