If you experience any problems, please visit bt.com/producthelp
7Getting started
2. Plug the other end of mains power adaptor into the wall socket and switch on.
3. Plug the end of the telephone line cord into the wall socket.
4. Check the dial mode setting.
The Mode switch on the underside of your BT Converse 2300 is pre-set to
TB for tone dialling with timed break recall. If your phone does not work, try
setting the dialling mode to P or T.
If you are not sure which setting to use, please contact your service provider or
switchboard manager.
Desk mounting plinth
If you want to remove the desk mounting plinth, push it in the same direction as
the two arrows shown on the plinth. To refit the desk mounting plinth, insert the
two lugs on the plinth into the base and push it down into place, as shown by the
blue arrows.
Your BT Converse 2300 is now ready for use.
Dialling mode
If connecting to a switchboard you may need to
adjust the dialling mode setting to P or T using
the Mode switch on the underside of the base.
If in doubt, please consult your service provider.
