Bedienungsanleitung BT Edge 1500 (Seite 7 von 54) (Englisch)

650281

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp

Battery low warning

The

icon ﬂashes in the handset

display when you have only a

few minutes talk time remaining.

Recharge the handset before you

can use it again. You also hear a low

battery warning beep if the battery

is low and needs recharging. During

charging, the icon will scroll in the

display.

Battery performance

In ideal conditions, a fully charged

battery should give up to 14 hours

talk time or 160 hours standby time

on a single charge.

Note that new batteries do not reach

full capacity until they have been in

normal use for several days.

To keep the battery in the best

condition, leave the handset off the

base for a few hours at a time.

Running the battery right down at

least once a week will help it last as

long as possible.

The charge capacity of rechargeable

batteries will reduce with time as they

wear out, giving the handset less talk/

standby time. Eventually they will

need to be replaced. New batteries

are available from the BT Edge 1500

Helpline on 0808 100 6556*. After

charging your handset for the ﬁrst

time, subsequent charging time is

about 6–8 hours a day. Batteries and

handset may become warm during

charging. This is normal.

Using your BT Edge 1500 on a

Broadband line?

If this product is to be used on a

broadband line then you must

ensure that it is connected via an

ADSL microﬁlter. Using this product

on a Broadband line without an

ADSL microﬁlter may cause

problems with this product and

your Broadband service.

Additional BT ADSL microﬁlters can

be purchased from www.shop.bt.com

2. Remove the protective ﬁlm from the handset screen and activate

the batteries by pulling the plastic tab away from the back of

the handset.

Rechargeable batteries

already fitted

Remove this tab

and charge batteries

for 24 hours before use.

3. Place the handset on the base to charge for at least 24

hours. When the handset is fully charged the

icon

will be displayed.

4. After 24 hours, plug the telephone line cord into the

telephone wall socket.

Note: if you ever need to remove the batteries, simply slide open

the battery compartment cover and insert your ﬁnger nail under

the end of the batteries to pull them out.

Setting up for multiple packs

If you have purchased a BT Edge 1500 multiple pack, you will

need to prepare any additional handsets and chargers for use.

For each additional handset and charger:

1. Insert the power adaptor with the red connector (item code

052300) into the underside of the charger. Plug the other end

into the mains wall power socket and switch on.

2. Remove the protective ﬁlm from the handset screen and

activate the batteries by pulling the plastic tab away from the

back of the handset.

3. Charge the handset for at least 24 hours. When the handset is

fully charged the

icon will be displayed.

Any additional handsets supplied as part of a multipack are

pre-registered to the base so, once charged, are ready for use.

The handset number is shown in the display.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BT Edge 1500 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BT Edge 1500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info