16
To reset your Synergy 1000 handset to its
original settings
• Press the ➔ button until display shows SET UP.
• Press the ✔ button. Display shows HANDSET.
• Press the ✔ button. Display shows KEYTONES.
• Press the ➔ button until the display shows
RESET.
• Press the ✔ button. Display shows CONFIRM.
• Press the ✔ button. Display shows CONFIRM
again.
• Press the ✔ button. Display shows REG.
The handset is reset, and is now de-registered
from the base station(s).
This will reset:
RINGER VOLUME to high.
RINGER MELODY to A.
EARPIECE VOLUME to medium.
KEYTONES to ON.
BACKLIGHT to ON.
Quickdial memory to shared.
It will delete
Quickdial numbers stored in the personal
memory.
Last number redial memory.
Personal emergency numbers.
Unchanged:
Quickdial numbers stored in the shared
memory.
You will now need to re-register your handset.
Follow the instructions on page 22.
To reset your Synergy 1000 base station to
its original settings
• Switch off the mains power.
• Press and hold down the
PAGE button.
Continue to hold down the
PAGE button while
switching the mains power back on and for a
further five seconds until the base station
gives a confirmation beep. After another five
seconds a second confirmation beep will
indicate that the base station reset is complete.
This will reset:
Base station PIN code to 0000.
Dial delay.
Recall mode.
Ringer volume.
Ringer melody.
It will remove:
All handsets registered to the base station.
All shared numbers stored in the memory.
Press the ✗ button to reverse one step of the
instructions. Or press and hold to revert
quickly to standby.
