22
Using additional handsets
Registering an additional Synergy
handset with the base station or re-
registering a handset
Up to six handsets can be registered and
operated from the Synergy 1000 base station.
The system allows intercom calls between two
handsets while a third is making an external call.
Each additional handset you purchase must be
registered with the base station.
To register a handset
At the base station:
• Press and hold down the blue
PAGE button
until you hear a beep (after about 10 seconds).
At the handset:
• Press the ➔ button until the display shows
SET UP.
• Press the ✔ button. Display shows HANDSET.
• Press the ✔ button. Display shows KEYTONES.
• Press the ➔ button until the display shows REG.
• Press the ✔ button. Display shows ADD.
• Press the ✔ button. Display shows PLS WAIT
then, after a short delay, the Park No. of the
base station.
• Press the ✔ button. Display shows PIN ----.
• Enter the four-digit base station code.
(Default 0000. Enter this if the base station
code has not been changed.) The ----marks
disappear one by one.
• Press the ✔ button. You hear a confirmation
beep. Display shows LABEL = (which refers to
the handset number).
• Press the ✔ button to automatically allocate
the next handset number.
• If you are re-registering your only or first
handset, enter
1, followed by the ✔ button.
You hear a confirmation beep.
Before registering a new handset
Remember to charge the batteries for at least
16 hours. When switched on, the handset will
display REG. This tells you that the handset is
not registered with the base station.
You now have up to 1 minute to register the
handset, during which the IN-USE light f lashes
on the base station.
Park No. is a unique number given to each
individual base station
