If wall mounting your BT Verve
3010 Executive, use this guide for
position.
Remove plinth from the Verve
base by gently lifting the two clips
and sliding upwards.
• Make sure that you are not
drilling into any hidden wiring
and check that the power cable
will reach from the mains socket
to the base. Switch the power
adaptor off at the mains and
remove the adaptor plug from
its socket.
• Drill two holes 35 mm deep
using a 5 mm drill, 72 mm apart
to take the wall plugs.
• Put wall plugs into the drill holes
and then insert both screws.
Leave 2-3mm between the head
of the screw and the wall. You
are now able to mount the base
to the wall.
• Fit the base onto the two screws.
If necessary, tighten or loosen
the screws for the best fit.
• Put the handset back in the base
and switch the power back on at
the wall socket.
WALL MOUNTING
