Bedienungsanleitung Buderus SSB512 (Seite 4 von 68) (Englisch)

636469

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

6720818454 (2016/02) US SSB

4 | Product description

NOTICE:

► This boiler must be installed by a licensed contractor/ gas tter.

Failure to do so shall void the product warranty.

► The boiler is intended only for the use for which it was specically

designed and built. Bosch is hereby excluded from any liability for

damages caused to persons, animals or property resulting from

installation errors, improper adjustment, maintenance or use.

► In order to ensure safety and correct operation, the installation shall

always take place in full compliance with the applicable codes and

following with the instructions provided by the manufacturer, and must

always be carried out by a licensed contractor / gas tter only.

► The equipment must be installed in appropriate place and in

combination with appropriate systems as specied by code.

► The unit may be exposed to temperatures between 5 deg F (-15°C)

and 150 deg F (65°C) in its original packaging. Do not expose the

unit to weather without the protection of the original packaging until

the boiler has been properly installed. Until then there is no frost

protection for the boiler.

► After removing the packaging check the integrity and completeness of

delivery and in case of non-compliance, contact your dealer.

► If there is a water loss, disconnect the boiler from the main power

supply, close the water supply and immediately call technical

assistance or installer/local contractor.

► Periodically check that the condensate drain is free from obstruction.

► Periodically check the system pressure. System pressure should be

checked when the system is in standby mode and no call for heat is

present.

► Maintenance is mandatory and shall be carried out at least once a

year.

► This manual shall be read carefully, in order to install and operate the

boiler appropriately, and safely.

► Boiler installations, settings and service should only be performed by

experienced licensed contractor / gas tter. End Users should only

make adjustments with the assistance of a licensed contractor / gas

tter.

► Any maintenance operation or service before disconnecting the boiler

from the main power supply is forbidden.

► Do not remove or modify safety equipment.

► Do not pull or twist the electrical wires, from the boiler, even if the

device is disconnected from the main power supply.

► Do not obstruct or reduce the ventilation openings.

► Do not install the unit outdoors.

► Do not leave any combustibles or containers of ammable substances

in the room where the boiler is installed.

► Keep packing material out of reach of children as it can be potentially

dangerous. It must be disposed of as required by law.

► The opening of metal casing of the device and removing of the cover

are prohibited to the end user. Any service on the boiler must be

carried out by authorized personal.

► It’s prohibited to dispose the product as domestic waste. The

separate disposal of a household appliance avoids possible negative

consequences for the environment and human health deriving from

inappropriate disposal and allows to recover the materials it is made

of in order to achieve signicant savings in energy and resources.

2 Product description

2.1 Introduction

• The gas-red condensing SSB boilers are designed to be used in

central heating systems. Any other use is prohibited.

• This boiler can be connected to an indirect storage tank for the

production of domestic hot water.

• There are several options for venting including single pipe, two pipe

and concentric see section “4.7 Venting and air piping system” for

details.

• The quality of the system water is very important. Poor water quality

can damage heating systems and boilers due to scale formation and

corrosion (see water quality section).

• The boilers can also function directly with any hydronic emitter.

When installing the boiler and system connections, the installer must

consider the total head loss and ow rates in order to adequately size

piping and circulator pumps.

• The SSB boiler can be connected to a room thermostat.

• An outdoor air temperature sensor must also be connected to the

boiler for an outdoor reset supply temperature control for increased

fuel efciency and comfort.

2.2 Scope of delivery

Fig. 1 Scope of delivery

Component Qty Packaging method

[1] Gas condensing boiler 1 Pallet

[2] Set of documents for

appliance

1 Plastic package

[3] Safety relief valve 1 Cardboard box on pallet

[4] LP conversion kit 1 Plastic package

[5] Universal Sensor for LLH

or DHW

2 Cardboard box on pallet

[6] Outdoor sensor 1 Cardboard box on pallet

6.75

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Buderus SSB512 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Buderus SSB512

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info