784864
25
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
25
SETTING FILTER
OR PURGE CYCLE
FREQUENCY
The display will show FFxx,
“xx” representing the number
of cycles per day. Use the Up
or Down key to adjust the
frequency. Use the Light key to
jump to the next parameter,
economy mode (EP).
The “Filter cycle” indicator
lights up when filter is on and
flashes when suspended.
SETTING FILTER
CYCLE DURATION
(not available on purge
systems)
The display will show Fdxx,
“xx” representing the dura-tion
in hours of the filter cycle. Use
the Up or Down key to adjust
the duration. Use the Light key
to jump to the next parameter,
filter or purge frequency (FF).
0 = no filtration
24 = continuous filtration
It is not recommended to set
this to "0".
PROGRAMMING STEPS
PROGRAM
MENU
The program menu is accessible
by holding down the Light key
for 5 seconds. In the program
menu the following parameters
can be set: clock, the filter or
purge cycles, economy mode
and temperature units. While
you are in the program menu,
use the Up or Down key to
adjust the parameters and use
the Light key to jump to the
next parameter.
The changes will be saved after
the confirmation of the last
parameter only. If there is no
action taken for 10 seconds, the
system will exit the program
menu without saving any
changes.
SETTING THE
CLOCK
Enter the program menu by
holding down the Light key
for 5 seconds. The display will
show the current clock setting
with the hour flashing.
Depending on factory settings
your system may be set to 24-
hour time or 12-hour time.
Setting the hour: Use the Up
or Down keys to adjust the
hours. Press the Light key to
jump to the next parameter,
the minutes.
Setting the minutes: Use the
Up or Down keys to adjust the
minutes. Press the Light key to
jump to the next parameter,
the filter or purge start time
(FS).
SETTING FILTER
OR PURGE CYCLE
START TIME
The display will show FSxx, “xx
representing the starting hour
of the cycle. Use the Up or Down
key to adjust the hours. Use the
Light key to jump to the next
parameter, filter duration (Fd).
PROGRAMMING
THE FILTER/ PURGE
CYCLES
Depending on system configu-
ration your hot tub will perform
either a filter or a purge cycle.
The filter cycle menu consists
of the following parameters:
the start time (FS), the duration
(Fd) and the frequency (FF).
The purge cycle menu consists
of the following parameters:
the start time (FS) and the
frequency (FF).
A filter cycle consists of start-
ing all the pumps and blower
in high speed for 1 minute
(purge step) then, the pump
associated with the filter
will run in low speed for the
remaining duration of the
filter cycle (clean step).
A purge cycle is used when
the hot tub is equipped with
a 24 hour circulation pump
which provides a continuous
clean step. It consists of
starting all the pumps and
blower in high speed for 1
minute.
USER INTERFACE  EASY 4
SETTING ECONOMY
MODE
This mode allows you to lower
the temperature set point of
the hot tub by 20 °F (11 °C)
during a certain period of
the day.
The display will show EPx, “x
representing the state of the
programmed economy (0 =
disabled, 1 = enabled). Use
the arrow keys to enable or
disable economy mode. Use
the Light key to jump to the
next parameter, economy start
time (ES).
Note that the parameters for the economy mode settings are
associated to specific low level configuration of the system that are
not present in all software revisions.
SETTING ECONOMY
START TIME
The display will show ESxx,
“xx” representing the hour at
which the economy mode will
become active. Use the Up or
Down key to adjust the hour.
Use the Light key to jump to
the next parameter, economy
duration (Ed).
When the Economy mode is ON,
the display will toggle between
the “Eco” message, the time,
and the water temperature.
SETTING ECONOMY
DURATION
The display will show Edxx, “xx
representing the duration in
hour of the economy mode. Use
the Up or Down key to adjust
the hour. Use the Light key to
jump to the next parameter,
temperature unit.
24 = continuous economy
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bueno Spa Atlanta wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info