779937
83
Zoom out
Zoom in
Vorherige Seite
1/105
Nächste Seite
MY20B05-42_1.0_18.07.2019 82
Cleaning and servicing
7.4.2 Checking the tyres
Check the tyre wear. The tyre is worn if the
anti-puncture protection or the carcass cords
are visible.
A specialist dealer will need to change the tyre
if it is worn.
7.4.3 Checking the rims
Check the rims for wear. The rims are worn as
soon as the black, all-round groove on the pad
friction surface becomes invisible.
Worn rims must be replaced by a specialist
dealer.
We recommend that you also replace the rims
at the same time as every second brake lining
replacement.
7.4.4 Checking and adjusting the tyre
pressure
7.4.4.1 Dunlop valve
The tyre pressure cannot be measured on the
simple Dunlop valve. The tyre pressure is
therefore measured in the filling hose when
pumping slowly with the bicycle pump.
It is recommendable to use a bicycle pump with a
pressure gauge. The operating instructions for the
bicycle pump must be adhered to.
Unscrew and remove the
valve cap.
Connect the bicycle pump.
Pump up the tyre slowly and
pay attention to the tyre
pressure in the process.
Correct the tyre pressure
according to specifications in
the Pedelec pass.
If the tyre pressure is too
high, unfasten the union nut,
let out air and tighten the
union nut again.
Remove the bicycle pump.
Screw the valve cap tight.
Screw the rim nut gently against the rim with
the tips of your fingers.
7.4.4.2 Presta valve
It is recommendable to
use a bicycle pump with a
pressure gauge. The
operating instructions for
the bicycle pump must be
adhered to.
Unscrew and remove
the valve cap.
Open the knurled nut
around four turns.
Carefully apply the
bicycle pump so that the
valve insert is not bent.
Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
The tyre pressure has been adjusted as per the
specifications.
Remove the bicycle pump.
Tighten the knurled nut with your fingers.
Screw the valve cap tight.
Screw the rim nut gently against the rim with the
tips of your fingers.
7.4.4.3 Schrader valve
It is recommendable to use
a bicycle pump with a
pressure gauge. The
operating instructions for the
bicycle pump must be
adhered to.
Unscrew and remove the
valve cap.
Connect the bicycle
pump.
Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
The tyre pressure has been adjusted as per the
specifications.
Remove the bicycle pump.
Screw the valve cap tight.
Screw the rim nut gently against the rim with
the tips of your fingers.
1
83

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bulls Ebikes Shimano 6100 - 2020 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bulls Ebikes Shimano 6100 - 2020

Bulls Ebikes Shimano 6100 - 2020 Bedienungsanleitung - Deutsch - 106 seiten

Bulls Ebikes Shimano 6100 - 2020 Bedienungsanleitung - Holländisch - 107 seiten

Bulls Ebikes Shimano 6100 - 2020 Bedienungsanleitung - Französisch - 108 seiten

Bulls Ebikes Shimano 6100 - 2020 Bedienungsanleitung - Italienisch - 110 seiten

Bulls Ebikes Shimano 6100 - 2020 Bedienungsanleitung - Spanisch - 111 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info