B U R L E Y P E T T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
|
7
Removing Floor
For cleaning, floor may be removed by lifting at
front. Photo 10a Remove floor cover from base for cleaning
Reinsert floor rear under nuts in trailer rear and D-rings on
sides. In front corners, snap floor under front nuts. Photo 10b
Installing Safety Flag
Join pole sections together. On trailer's left side, insert flag
pole into flag receptacle on axle. DO NOT USE TRAILER
WITHOUT FLAG.
Operating Kickstand (Tail Wagon Only)
Use side knob to raise and lower kickstand.
Using Trailer as a Stroller (Tail Wagon Only)
Slide tow bar through both receptacles on left side. Line up
front tow bar hole with rear receptacle hole. Insert retaining
pin through both holes and lock retaining hoop securely. Place
stroller wheel in the “STROLL” (down) position and tighten knob.
To adjust wheel tracking (which allows stroller to roll straight):
1. Loosen bolt using 5 mm hex wrench. Figure 1
2. With 25 mm (1") wrench, adjust bushing until wheel is
aligned and trailer tracks straight.
3. Tighten bolt.
NOTE: Stroller and kickstand
available as accessories for the Rover.
