Bedienungsanleitung Bury CC 9068 App (Seite 34 von 44) (Englisch)

607782

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Operating guidelines

Audio

In this area you have the possibility to change the audio settings of the

HFCK.

The HFCK is sold with four Ringtones from which you can respectively

select one. With „NEXT“ or „PREVIOUS“ you can navigate in the list.

With „ACCEPT“ the ring tone is selected. If you would like to use your

mobile phone’s ring tone, please select the first entry in the menu.

Please remember, however, that not every mobile phone can transfer

its ring tone to the HFCK.

The volume level for the voice feedback and the selected ring tone can

be set in an additional sub menu. Available as voice commands are

„LOUDER“, „LESS“, „MAXIMUM“, „MINIMUM“ and „ACCEPT“.

For some radios it may cause problems if the HFCK starts with voice

response immediately after the mute signal. Some radios need some

time for a corresponding activation and reaction to the mute signal.

This will be indicated to you through the fact that you don’t hear the

signal tone at the start of the voice control. To avoid this effect, you can

enter a maximum delay of up to three seconds in the „MUTE DELAY“

menu item. It is only after this time has elapsed that the HFCK begins

with the voice feedback.

Certain mobile telephones offer the possibility of being able to install

and operate a navigation solution. On many mobile phones, the sug-

gested directions are only transferred via the Bluetooth A2DP profile. If

you have not connected a suitable cable to the LINE-OUT output of the

HFCK and to the radio however, you are not able to hear these instruc-

tions.

With the External Audio menu item, it is possible to place these in-

structions on the PHONE-OUT output of the HFCK. This means that the

direction instructions are read out in monotone and the radio is also

muted. The HFCK takes priority with its functions, however, which

means that if the voice control is active or in the event of an incoming

call, any direction instructions that are being issued at that time will be

muted.

Please note:

If the function is activated it is not possible to listen to X

music via A2DP via the LINE-OUT output.

The “Balance” command is used to compensate or adjust the volume

between the left and right side. “Installation” involves two options:

- Option 1 (all through the box):

Connection -

ISO-power connector plugged in, ISO-audio connector

connected (box active).

Phone call -

uses two front speakers and an internal amplifier in the

box. Car speakers are disconnected from the radio and connected to

the box (active). RadioMute line is also active and will turn off the radio

(Mute or switching to PHONE IN mode, depending on the radio).

Audio

Ringtones

Play

Select

Volume

Speech

Ringtone

Mute delay

External audio on

Balance

Installation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bury CC 9068 App Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bury CC 9068 App

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info