Bedienungsanleitung Cadac 20162 - Urban-Citi Chef 50 (Seite 5 von 9) (Englisch)

684194

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

5. Fitting and Changing the Hose and Gas Cylinder

• NOTE! When installing the tailpiece, ensure it is held straight while tightening the tailpiece

nut, in order to prevent a possible gas leak. Tighten with a suitable spanner. (Fig. 10)

• I 3B/P (30), I 3B/P (37) and I 3+ (28-30/37) Appliance categories: Fit the valve tailpiece

onto the valve by screwing it on in an anti-clockwise direction. Push an approved hose

onto the valve tailpiece until it is properly seated. On the other end, attach a suitable

low pressure regulator (I3B/P (30) : 30 mbar G30/G31 con gurations regulator; I3+(28-

30/37): 28~30 mbar G30 regulator or 37 mbar G31 regulator); I3B/P(37): 37 mbar G30/

G31 con gurations regulators). Again making sure that the hose is well seated. The type

of hose used shall comply with the relevant EN standard and local requirement. In South

Africa the regulator used must comply with SANS 1537.

• I 3B/P (50) Appliance category: Screw a Hose with the correct threaded  ttings on each

end, onto the left hand ¼“ BSP thread of the Valve. Attach a suitable 50 mbar G30/G31

low-pressure regulator on the other end of the hose. The hose used must comply with DIN

4815 part 2 or equivalent.

• The hose length should be no less than 800mm and shall not exceed 1.5m. Check the manufacture date on the hose and replace

when necessary or when national regulations require it.

• Do not twist or pinch hose. Ensure the hose does not come into contact with any surfaces that would become hot during use.

• Before  tting the regulator to a gas container, ensure that the seal on the regulator is in position and in good condition. This should be

done with every connection and before every use.

• Before  tting your gas cylinder, ensure that the valves are all in the “OFF” position by turning the control knob clockwise to its stop.

• Ensure that the gas container is  tted or changed in a well-ventilated location, preferably outdoors, away from any source of ignition

such as naked  ames or electric  res and away from other people.

• Making sure that the gas container is kept upright, screw the regulator onto the container until it is fully engaged. Hand-tighten only.

• If there is a leak on your appliance (smell of gas), close the cylinder valve immediately and follow the procedure to detect and stop a

leak under Section 3. If you wish to check for leaks on your appliance, do it outside using soapy water only, which is applied to the

joints. A formation of bubbles will indicate the gas leak.

• Check that all the connections are securely  tted and re-check with soapy water. If you cannot rectify the gas leak, do not use the

appliance. Contact your local CADAC stockist for assistance.

• When changing a gas container,  rstly close the container valve (if  tted) and then turn the control knob clockwise to its stop position.

• Ensuring that the  ame is extinguished, unscrew the regulator. Re t a full container following the same precautions as described

above.

6. Lighting the appliance

Precautions to observe before lighting.

• After prolonged storage, inspect the air holes in the valve cover for insects, which may affect gas  ow. Inspect the inlet of the venturi

for insects. After checking, re t all components into the prescribed position.

• Use this appliance only on a  rm level surface.

Using the control knob

The control knob is  tted with two positive stop positions, one at low, and one at Ignite / High. This limits the adjustment of the  ame

to between these two points.

Lighting up using the Piezo Igniter

• To light up the appliance using the piezo igniter, push in and turn the control knob in an anti-clockwise direction until you hear a

click. If the gas does not ignite on the  rst spark, push in, and turn the control knob fully clockwise. Try again, by pushing in and

turning the control knob anti-clockwise until you hear a click. If the gas has not ignited in the  rst two to three seconds you should

close the control valve by pushing in the control knob, and turning it fully clockwise. Wait approximately thirty seconds to let any

accumulated gas within the burner pan assembly escape. Repeat the above process if necessary until the  ame ignites. The  ame

should normally light up within the  rst one or two seconds.

Lighting up using a BBQ lighter

• When starting cold, the appliance may be lit from the top prior to  tting the desired cooking surface onto the fat pan. When lighting

up a hot appliance however, it is recommended that this be done by sticking barbecue lighter through one of the Vent Holes

underneath the Burner, until it is in line with the burner(DO NOT place the BBQ lighter through the large hole directly underneath the

burner). Ignite the BBQ lighter. Whilst the BBQ lighter is lit, push in and turn the control knob anti-clockwise to light the burner.

General

• Once the appliance is lit, the  ame intensity may be adjusted by turning the valve knob anti-clockwise to reduce the  ame, or

clockwise to increase the  ame.

• The fully closed position is at the furthest clockwise position. To rotate the valve from the fully closed position it is necessary to  rst

depress the knob just enough to move out of the lock mechanism. While holding the knob in, turn it in an anti-clockwise direction.

Once the spindle has moved out of the lock position it is no longer necessary to keep the control knob depressed and it can be rotated

freely to the desired  ame setting.

• When cooking food with a high fat content,  aring may occur if the selected heat setting is too high. Should this happen, turn the heat

down until the  aring ceases.

Fig. 10

503-0623 LEV9 - (20162) Urban-Citi Chef 50 - User Manual (EU & SA).indd 4 19/06/2017 11:00:32

Cadac 20162 - Urban-Citi Chef 50 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadac 20162 - Urban-Citi Chef 50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info