Bedienungsanleitung Cadac 5900 - Cook 200 (Seite 3 von 22) (Holländisch)

684174

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

This appliance is designed to comply with BSEN 521:2006 and SANS 1539: 2006

Appliance category: Vapour pressure - Propane/Butane mix

This appliance shall only be used with the CADAC 500g disposable threaded resealable gas

cartridge (Model CA500) complying with EN417.

It may be hazardous to attempt to fit other types of gas cartridges.

Nominal Usage: 167g/hour

Gross Nominal Heat Input: 2.34kW

This product uses a CADAC 0.25 Jet

Gas appliances require ventilation for efficient performance and to ensure the safety of users and other

persons in close proximity.

Use Outdoors only!

1. General

2. Safety Information

Check that the seal is in place and in good condition before connecting the gas cartridge to the

appliance (see fig. 1).

Do not use an appliance that is leaking, damaged or which does not operate properly (malfunctioning).

Always operate the appliance on a level surface.

Always operate the appliance safely away from flammable materials. Minimum distances are

120cm above the appliance and 60cm to the rear and sides (see fig. 2).

Ensure that the gas cartridge is fitted or changed in a well-ventilated location, preferably outdoors,

away from any sources of ignition, such as naked flames, and away from other people.

If suspect a leak on your appliance (smell of gas), take it outside immediately into a well-ventilated

flame free location where the leak may be detected and stopped. If you wish to check for leaks on

your appliance, do it outside.

Never leave the appliance unattended when lit.

Do not modify the appliance. Do not use it for anything for which it has not been designed.

Do not use the appliance if it has a damaged or worn seal.

Do not try to detect leaks using a flame, the correct way

is to use soapy water.

CAUTION

IMPORTANT

Provide ample ventilation. This gas appliance consumes air (oxygen). Do not use this appliance in an unventilated space to avoid

endangering your life. If still more gas appliances and/or occupants using gas are added to the space, additional ventilation must

be provided.

Read these instructions carefully so as to familiarise yourself with the appliance before use.

Retain these instructions for future reference.

Before each use, ensure that the fat pan is clean and free of fat .

Keep young children away from the appliance at all times.

Handle the appliance with care, do not drop it.

During use, parts of the appliance will become hot (particularly the burner). Avoid touching hot parts

with your bare hands. If you have the need to touch a hot appliance, use gloves.

Before fitting the cartridge to the appliance, ensure that the valve seal is place and in good condition.

Carry out this check each time you fit a cartridge.

(Model 5910 Only)

Ensure that the control knob is turned off (turned fully clockwise) (see fig. 3).

Keep the cartridge upright when fitting it to the appliance. Carefully screw the cartridge into the

appliance, taking care not to screw the cartridge cross-threaded. Screw the cartridge on hand tight

only. Do not over tighten as you may damage the cartridge and appliance threads.

Check that the cartridge is connected to the appliance in a gas tight fashion, showing no signs of

leakage (check for the smell of gas around the connection joint). If you suspect that the connection in

not gas tight enough, soapy water must be applied to the joint (the appliance must not be fully

immersed in soapy water as this may result in an unsafe operation of the appliance). Any leak will be

seen as bubbles coming from the leakage point.

If you cannot remedy any leakage, unscrew the cartridge from the appliance and return the appliance

to your nearest CADAC stockist.

If you suspect a leakage from your appliance during use, immediately turn off the appliance control

knob (turned fully clockwise), take the appliance outside and follow the instructions above.

To light the appliance, hold a flame to the burner, turn the control knob slowly anti-clockwise and light

the burner (see fig. 4).

After lighting, do not move the appliance around during the warm up period (1 minute), as liquid gas

may enter the appliance from the cartridge causing it to flare (large yellow flames).

If flaring occurs, turn down the control knob until the flaring stops.

When in use, protect from wind for optimum performance.

Adjust the size of the flame by turning the control knob. To increase the size of the flame, turn the

control knob in the direction of the ‘+’ (anti-clockwise). To decrease the size of the flame or to turn the

appliance off, turn the knob in the direction of the ‘-’ (clockwise) (see fig. 3).

After use, always ensure the control knob is turned fully off and the appliance has cooled down

sufficiently to be able to be packed away.

In the event of light back, where the flame burns back and ignites inside the burner or venturi housing,

immediately turn the appliance off by turning the control knob fully clockwise. After the flame is

extinguished, remove the gas cartridge and check the condition of the seal; replace the seal if in doubt.

Re-light the appliance as described above. Should the flame persistently light back, return

the product to your authorised CADAC repair agent.

Flaring may also occur if food with a

high fat content is cooked with the heat setting too high. In this instance, reduce the heat setting by

adjusting the control knob.

3. Using The Appliance

Seal

Fig. 1

Fig. 2

60cm

120cm

60cm

Flammable

Fig. 3

Fig. 4

Cadac 5900 - Cook 200 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadac 5900 - Cook 200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info