Bedienungsanleitung Cadac 98522 (Seite 4 von 5) (Englisch)

684209

Zoom out

Zoom in

Vorherige Seite

1/5

Nächste Seite

8. Storage

Ÿ Handle the appliance with care. Do not drop it.

Ÿ After use, wait until the appliance has cooled down, disconnect it from the gas cylinder and store in a cool dry place away from heat.

Ÿ Keep the hood closed when not in use to prevent dirt and insects falling into the unit, which may affect the gas flow.

Ÿ Use a CADAC BBQ cover, especially if the unit is stored outdoors.

Ÿ Before every use, ensure that the burners and venturies are free of insects, dust and spider webs.

Ÿ To clean the body, simply wipe with a damp cloth using a little detergent if necessary.

Ÿ Do not use abrasive cleaners or scourers as this will cause permanent damage to the painted surface.

Ÿ Even though stainless steel is remarkably resistant to tarnish and rust relative to ordinary steels, it still requires proper care. We recommend the following:

Ÿ After use, clean the stainless steel surfaces with clean water and a soft cloth for light cleaning, while a commercially available stainless steel cleaner with a

soft cloth should be used for tougher areas. Ensure that you remove all excess stainless steel cleaner after cleaning your BBQ.

Ÿ To repair minor tea staining or pitting, you can use a light, non-metallic scourer. It is important that you rub with the natural grain of the stainless steel

surface to avoid leaving visible scratch marks.

Ÿ Between uses, it is a good idea to leave the barbeque covered to prevent dust and air borne salts settling on the stainless steel surfaces. If left for too long,

these particles can act as rust centres.

Ÿ With a small amount of care, your investment in quality stainless steel will keep its beautiful finish as well as its value for a long time to come

14. Warranty Cont....7. Cleaning

5. General Maintenance

Ÿ There are no predetermined maintenance intervals for this appliance.

Ÿ It is dangerous to use an appliance with a cracked or perished seal and/or hose. Inspect both seals and hose regularly and replace if they are not in order

before using the appliance.

Ÿ If the appliance was in use it will be hot. Allow to cool sufficiently before attempting any maintenance.

Ÿ CADAC Patio BBQ's are fitted with spesific CADAC jets to regulate the correct amount of gas. Should the hole in the Jet become blocked this may result in

a small flame or no flame at all. Do not attempt to clean the Jet with a pin or other such device as this may damage the orifice, which could make the

appliance unsafe. Refer to Table 1 for jet sizes.

5.1. Replacing a Blocked Jet

Ÿ Ensure that the cylinder valve is closed, then disconnect the appliance from the gas cylinder.

Ÿ Remove the grill plates. Remove the flame tamers to expose the burners. Remove the retaining screws of the affected burner.

Ÿ Remove the affected burner by lifting it out of its location taking care not to damage the control valve whilst doing so. This will expose the Jet.

Ÿ Unscrew the blocked Jet with a suitable spanner and replace it with a new Jet. Do not use pliers on the Jet as they can cause damage, making the Jet

unusable or impossible to remove.

Ÿ Do not over tighten as this may damage the Jet. To re-assemble, reverse the above procedure.

5.2. Replacement of Hose

Ÿ The hose length should not be less than 0.8m or exceed 1.2m. Check the date of manufacture on the hose and replace if it shows signs of cracking or

brittleness. Fitting of a hose is described in Figure 1b. Only an LPG hose that complies with local regulations may be used with this appliance.

5.3. Replacement of Regulator

Ÿ Use a 30mbar (for butane or propane) regulator with gas category I3B/P(30).

Ÿ Use a 30mbar (for butane) regulator or a 37mbar (for propane) regulator with gas category I3+(28-30/37).

Ÿ Use a 37mbar butane(or propane) regulator with gas category I3B/P(37).

Ÿ It is important that the connection between the regulator outlet and the low pressure hose is tight and that it is secured with a metal hose clamp. Always

check the joint for gas leaks as described in section 3 above.

6. Troubleshooting

Ÿ A normal flame is blue and may have an orange or yellow tip. If the flame is completely yellow, it may be that the jet is not securely fitted. Re-tighten the jet

to ensure there is no gas leakage. An overfilled gas cylinder can also cause large yellow flames. If this is the case the cylinder should be returned to the

filling station and checked by weight.

Ÿ Check that the primary air supply apertures (holes) in the Burners are clear and free of obstructions.

Ÿ If the flame power drops or the gas will not light, check that the gas cylinder still contains gas (shake to hear the noise made by a liquid). If there is still gas,

the jet might have become blocked or partially blocked.

Ÿ If you suspect a blocked jet, follow the instructions above.

4. Fitting and changing the gas cylinder continued

Ÿ Make sure that the gas cylinder is kept upright at all times. Hand tighten the regulator onto the cylinder until it is fully engaged.

Ÿ If there is a leak on your appliance (smell of gas), extinguish all sources of ignition in the vicinity of the appliance. If you wish to check for leaks on your

appliance, use soapy water which is applied to the suspected area. A formation of bubbles will indicate a gas leak. Check that all the connections are

securely fitted and re-check with soapy water. If you cannot rectify the gas leak, do not use the appliance. Contact your local CADAC stockist for assistance.

Ÿ When changing a gas cylinder, first close the cylinder valve and then the appliance valve, making sure the flame is extinguished and unscrew the regulator.

Re-fit the regulator to a full cylinder following the same precautions as described above.

Ÿ After the appliance has been fully assembled, perform a gas leak test before operating the appliance.

Cadac 98522 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadac 98522

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info