Bedienungsanleitung Cadac Safari Chef 30 compact - 6525L1 (Seite 5 von 132) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

819981

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

Seal

Fig. 3c

Fig. 3a Fig. 3b

Notch

Safety Guide Fig. 3d

3. Operating the Appliance

• When operating this appliance, please take care to ensure that all parts are in good working order and that you have checked for any gas

leaks before lighting the appliance with every use.

• Cooking surfaces can simply be placed and are ready to use. No assembly required.

• PLEASE NOTE: Please ensure all protective packaging and plastic are removed from the appliance before use.

• The appliance is designed for use with cooking vessels of not less than 150mm in diameter and not greater than 300mm in diameter.

Precautions to observe before lighting.

• Use this appliance only on a ﬁrm level surface.

• Aer prolonged storage, inspect the appliance for any insects and webs, which may aﬀect gas ﬂow.

Lighting the appliance using the piezo

• It is recommended to remove any cooking surfaces when trying to light the appliance. This way it will be easy to see the burner when it is lit.

• To light up the appliance using the piezo igniter, push and turn the control knob in an anticlockwise direction until you hear a click. If the gas

does not ignite on the ﬁrst spark, turn the control knob back to its “OFF” position. Try again, by pushing and turning the control knob

anti-clockwise until you hear a click. If the gas has not ignited in the ﬁrst two to three seconds you should close the control valve by turing

the control knob back to its “OFF” position.

• Wait approximately thirty seconds to let any accumulated gas within the burner escape. Repeat the above process if necessary until the

ﬂame ignites. The ﬂame should normally light up within the ﬁrst one to two seconds.

Lighting up using a BBQ lighter

• When starting cold, the appliance may be lit from the top prior to ﬁtting the desired cooking surface onto the fat pan. When lighting up a

hot appliance, it is recommended that this be done by sticking a barbecue lighter through one of the vent holes underneath the burner,

until it is in line with the burner (DO NOT place the BBQ lighter through the large hole directly underneath the burner). Ignite the BBQ

lighter. Whilst the BBQ lighter is lit, push and turn the control knob anti-clockwise to light the burner.

General

• Use the control knob to adjust the ﬂame intensity to the desired level by turning the knob clockwise to decrease the ﬂame and anti-

clockwise to increase the ﬂame.

• When cooking food with a high fat content, ﬂaring may occur if the selected heat setting is too high. Should this happen, turn the heat down

until the ﬂaring ceases.

• Do not move the appliance when in use. It is unsafe practice to move the appliance whilst lit and may cause ﬂaring.

• When not in use remove the gas cartridge.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadac Safari Chef 30 compact - 6525L1 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info