Bedienungsanleitung Cadel Eolo (Seite 23 von 40) (Englisch)

694380

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

EOLO - COMFORT 80

POS. REFERENCE DESCRIZIONE

10 FLAME SETTING Enables to adjust the ame depending on chimney ue draught.

11.5 IGNITION

We remind you that the rst ignition must be executed by authorized and skilled technical personnel who checks

that all is installed in compliance with current regulations and veries stove’s efciency.

• If inside the combustion chamber there are booklets, manuals, etc.… please remove them.

• Check if there are pellets in the hopper.

• Check that the door is correctly closed.

• Check that the plug is correctly put into the electric socket.

• Before starting up the stove, please assure you that the burning pot is clean.

• To start up the stove, keep pressed P4 key for little while till it appears “START” and then “PREHEATI WAIT”

which starts the preheating of the ignition resistance. After 2 minutes, the display shows “PELLET LOAD, FIRE

WAIT” when the auger load the pellet and the heating of the resistance goes on. When the temperature is

sufciently high (after about 7-10 minutes), the ignition has occured and the display shows “FLAME PRESENT”.

• When “FLAME PRESENT” stage has nished, the control unit enters on “WORK” mode and displays the selected

caloric power and room temperature. It is in this stage that P5 and P6 keys adjust the power from 1 to 5. If

room temperature exceeds the limit established during the setting, the caloric power falls at the minimum

displaying “WORK, MODULAT”. When the room temperature returns below the selected temperature, the

stove returns to the set power.

11.6 STOVE ADJUSTMENT

The stove is set in compliance with chimney ue and used pellets data, according to technical characteristics

(see FEATURES page 38). If the data do not correspond, the technician can set the stove.

• If the pellets is small in size and with a greater caloric power, (for example because of encrusted re pot)

decrease the pellet drop through the menu “FLAME SETTING”, press P3 key “PELLET TYPE”, press again P3

“PELLET LOAD” and with P2 key decrease the pellet quantity from -1 (i.e. -2%) to -9 (i.e. -18%).

• If the chimney ue has a lower draught (for example because of a weak ame or sooty glass) increase

the fume motor revolutions through the menu “FLAME SETTING”, press P5 key “CHIMNEY TYPE”, press P3 key

“FUME-EXT, CHIMNEY” and with P1 key increase the exhaust fan from +1 (i.e. +5%) to +9 (i.e. +30%).

• If the chimney ue has a greater draught (for example because of pellet fall from the burning pot) decrease

the exhaust fan revolutions from -1 to -9.

Pay attention to positive and negative values.

11.7 FAILED IGNITION

If the pellets do not burn, the failed ignition will be indicated by the alarm “NO IGNITION”

• If the room temperature is lower than 10°C, the plug is not able to bear the ignition stage. To support it please

insert some pellets in the burning pot and a piece of burning relighter igniter material on the pellets (for

example relighters cubes).

After a failed ignition the burning pot must be empty from the amassed pellets, before

starting up again the stove.

• Too much pellets in the burning pot, or humid pellets, or sooty burning pot make ignition difcult and create

dense white smoke which is harmful to health and can cause explosions on the combustion chamber. It is

therefore necessary not to stand in front of the stove during ignition stage if dense white smoke is present.

If after some months the ame appears weak and/or orange colored or the glass tends to

blackens and the burning pot to become encrusted, clean the stove, clean the fume pipe

and the chimney ue.

11.8 POWER FAILURE

• After a black-out off less than 5 seconds, the stove returns to the set power.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel Eolo Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel Eolo

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info