Bedienungsanleitung Cadel Ibis 22 H2O (Seite 27 von 56) (Englisch)

643494

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

AQUOS - IBIS - IDRON

If you have very extensive systems (with a large amount of water) or which require frequent relling, the installation

of water softening systems.

It should be remembered that incrustations drastically reduce performance due to their

extremely low thermal conductivity.

ELECTRICAL CONNECTIONS

9.1 GENERAL PRECAUTIONS

Electrical safety of the system is ensured only when it is properly connected to an efcient earthing system made

in compliance with the safety standards in force: gas, water or heating systems pipes are not suitable as earth

connections.

One must check this essential safety requirement; if in doubt, request an accurate inspection of the electrical

system to be carried out by qualied personnel, because the boiler manufacturer is not responsible for any

damage caused by failure to earth the system.

Have professionally qualied personnel check the electrical system is suitable for the maximum power absorbed

by the heating system, ensuring in particular that the diameter of cables is appropriate for the power absorbed

by the loads.

The use of any component that is powered by electricity entails compliance with some basic rules such as:

• do not touch the appliance with wet and/or damp body parts and/or bare feet;

• do not pull the electric cables;

• do not leave the appliance exposed to weathering (rain, sun, etc.);

• do not allow the appliance to be used by children or inexperienced persons.

230V electrical power supply connection

Installation of the boiler accessory electrical components requires electrical connection to a 230 V – 50 Hz mains:

This connection must be state of the art according to the CEI standards in force.

Hazard!

Electrical installation must be carried out by a qualied technician only.

Before performing connections or any operation on the electrical parts, always disconnect

the power supply and make sure it cannot be accidentally reconnected.

Please note that the boiler electrical power line must be tted with a bipolar switch with

a contact gap greater than 3 mm, easy to access, in order to make any maintenance

operations quick and safe.

The power cable must be replaced by authorised technical personnel. Failure to comply with the provisions

listed above may compromise the safety of the appliance.

9.2 ELECTRICAL CONNECTION

First connect the power cable to the side of the boiler and then to a wall socket.

The main switch at the side must only be activated to switch the boiler on; otherwise, it is advisable to keep it

switched off.

It is recommended to disconnect the boiler power cable when the boiler is not used.

Fig. 25 - Electrical connection of the stove

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel Ibis 22 H2O Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel Ibis 22 H2O

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info