Bedienungsanleitung Cadel Ibis 22 H2O (Seite 44 von 56) (Englisch)

643494

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

AQUOS - IBIS - IDRON

14.15 ALARM RESET

To reset the alarm one must press and hold key 1 (ESC) for a few seconds. The boiler performs a check to

determine if the cause of the alarm persists or not.

In the rst case the alarm will still be displayed, in the second case it will go onto OFF.

If the alarm persists, contact the service centre.

14.16 NORMAL SHUTDOWN (ON THE PANEL: OFF WITH FLASHING FLAME)

If the shutdown key is pressed or if there is an alarm signal, the boiler goes into the thermal shutdown phase which

entails the automatic execution of the following stages:

• It stops pellets loading

• The room fan (if provided) maintains the set speed until the smoke T reaches 100°C, then it automatically sets

itself at the minimum speed until it reaches the shutdown temperature

• The smoke fan sets itself at maximum speed and maintains it for a xed time of 10 minutes, at the end of which

if the smoke T has fallen below the shutdown threshold it switches off permanently, otherwise it sets itself at the

minimum speed until it reaches such threshold before switching off.

• If the boiler was shutdown regularly but, due to thermal inertia the smoke temperature exceeds the threshold

again, the shutdown stage restarts at the minimum speed until the temperature goes down.

14.17 BLACKOUT WITH THE BOILER ON

In the event of a power cut (BLACKOUT) the boiler behaves as follows:

• Blackout below 10”: it returns to its operation in progress;

• In the event of a power cut that lasts over 10” with the boiler on or in the start-up stage, when the boiler is

powered again it goes back to the previous operating condition with the following procedure:

1) It cools down activating the smoke extractor at minimum power for 10’ and goes onto the next point;

1) It takes the boiler back to the operating condition before the blackout.

During stage 1 the panel displays ON BLACK OUT.

During stage 2 the panel displays Start-up.

If during stage 1 the boiler receives commands from the panel and thus carried out manually by the user, then

the boiler stops executing the blackout recovery status and proceeds to restart or shutdown as requested by

the command.

14.18 BLACKOUT ABOVE 10” WITH BOILER IN SHUTDOWN STAGE

In the event there is a power cut that lasts MORE THAN 10” with the boiler in the shutdown stage, when the

boiler is powered again it restarts in shutdown mode even if the smoke temperature has fallen under 45°C in the

meanwhile. This last stage can be skipped by pressing key 1 (esc) (it goes into start-up) and by pressing it again

(it recognises that the boiler is switched off).

MAINTENANCE AND CLEANING

Fig. 37 - Example of a clean brazier Fig. 38 - Example of a dirty brazier

ATTENTION!

All the cleaning operations of all parts must be performed with a completely cold product

and the plug disconnected.

The product requires little maintenance if used with certied high quality pellets.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel Ibis 22 H2O Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel Ibis 22 H2O

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info