Bedienungsanleitung Cadel INDACO 11 (Seite 22 von 36) (Englisch)

814949

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

KOBE - FENICE - SPARK - INDACO - PRINCE - GO - ECLIPSE

8.18 SMOKE RPM VARIATION SEE SECTION I SETTINGS MENU A PAG. 14

Changes to be made with the support of the authorised technician.

Activates only with the Easy Set function disabled, "SET: 0" !

If the installation presents difficulties for smoke evacuation (no draught or no pressure in the duct), the smoke and ash expulsion

speed can be increased. This change resolves all the potential problems related to pellets clogging in the brazier and deposits

forming at the bottom of the brazier itself caused by poor quality fuel or fuel that produces a lot of ashes. The values available are

from -27% to +27% with variations of 3 points at a time. The variation in negative can be used in case the flame is too low.

8.19 CHIMNEY SWEEP FUNCTION FOR MAINTENANCE TECHNICIANS ONLY  SEE SECTION K SET

TINGS MENU A PAG. 14

This function can be activated only when the boiler is on and with power output and heating operation power with parameters

P5, with fan (if present) in V5. Any loading/smoke ventilation percentage corrections must be taken into account. This status lasts

20 minutes, the countdown is displayed on the panel. At any time the technician can interrupt this stage by quickly pressing the

on/off key.

9 FUEL

9.1 FUEL

• Use top-quality pellets because they have influence in the calorific value and in ash remains.

• Not adequate pellets cause a bad combustion, a frequent burning pot obstruction and exhaust conduits obstruction. Further it

decreases the calorific value, soils the glass and increases consumptions and ash and unburnt granules quantity.

Humid pellets cause a bad combustion and running, so please assure you that they are stored in dry places and

far at least one meter from the stove and/or any other source of heat.

• It is advisable to try different type of pellets available on the market and to choose that which gives the best performance.

• Pellets of variable quality and size are available on the market: the smaller the pellet, the greater the fuel supply, resulting in

poor combustion

Depending on the type of pellets it could be necessary a parameters adjustment, please contact an Authorized

Assistance Service.

The main quality certifications for pellets currently available on the European market guarantee that the fuel complies with class

A1/A2 according to ISO 17225-2. These certifications include, for example, ENPlus, DINplus, Ö-Norm M7135, and specifically assure

that the following characteristics are complied with:

• calorific value: 4.6 - 5.3 kWh/kg.

• Water content: ≤ 10% of the weight.

• Percentage of ash: max 1.2% of the weight (A1 less than 0.7%).

• Diameter: 6±1/8±1 mm.

• Length: 3-40 mm.

• Content: 100% untreated wood without the addition of binding agents.

The company recommends using certified fuel for its products (ENPlus A1, DINplus, Ö-Norm

M7135).

The use of pellets that do not comply with the characteristics specified previously may com-

promise the operation of your product and therefore invalidate the warranty and product

liability.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel INDACO 11 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel INDACO 11

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info