Bedienungsanleitung Cadel MIRA 16 (Seite 10 von 72) (Englisch)

696847

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

IDRO PRINCE

12-16-23-23 H

O - IDRO PRINCE 30-30 H

O - AQUOS

16-23-23 H

O - IDRON 16-22 AIRTIGHT - MIRA 16-22 -

TESIS 16-23

AIRTIGHT - HIDROFIRE 22.8

Fig. 2 - Safety distance

MODEL NON-FLAMMABLE WALLS FLAMMABLE WALLS

IDRO PRINCE

12 A = 5 cm / B = 5 cm A = 20 cm / B = 20 cm

IDRO PRINCE

16-23-23 H2O A = 5 cm / B = 5 cm A = 20 cm / B = 20 cm

IDRO PRINCE 30-30 H2O A = 5 cm / B = 5 cm A = 20 cm / B = 20 cm

AQUOS

16-23-23 H2O A = 5 cm / B = 5 cm A = 20 cm / B = 20 cm

IDRON 16-22 AIRTIGHT A = 5 cm / B = 5 cm A = 20 cm / B = 20 cm

HIDROFIRE 22.8 A = 5 cm / B = 5 cm A = 20 cm / B = 20 cm

If the floor is made of combustible material, we recommend using a protector made of incombustible material (steel, glass) that

also protects the front part from any falling burnt particles during cleaning.

The appliance must be installed on flooring that has an appropriate load-bearing capacity.

If the existing construction does not meet this requirement, appropriate measures must be taken (for example, a load distribution plate).

3.5 FOREWORD

This Flue chapter was written in reference to European standard requirements (EN 13384 - EN 1443 - EN 1856 - EN 1457).

It provides some instructions on how to properly install the flue but it does not in any way replace the standards in force, of which

the qualified manufacturer must be in possession. Check with the local authorities whether there are stricter standards regarding

the combustion air vent, the smoke exhaust system, the flue, the chimney cap.

The company declines all liability regarding poor stove operation if it can be attributed to using an incorrectly sized flue that does

not meet the standards in force.

3.6 FLUE

The flue or chimney is extremely important for forced draft heating appliances fired by solid fuels to work properly, as modern

heating appliances are high performing with cooler smoke and, as such, less draft. Thus, it is fundamental for the flue to be built

properly and always kept perfectly efficient. A flue serving a pellet/wood appliance must be at least category T400 (or above if

the appliance requires it) and resistant to soot fire. Smoke must be extracted via individual flue with insulated steel pipes (A) or

existing flue and must comply with the intended use (B).

A simple cement cavity must be appropriately ducted. Both solutions require an inspection cap (AT) and/or inspection door (AP) - FIG.1.

Do not connect more than one wood/pellet or other types (exhaust hood) of appliance (*) to the same flue.

(*) unless there are national exceptions (for example, in Germany), which allow more than one appliance to be installed in the same

chimney under opportune conditions; in any case, scrupulously follow the product/installation requisites provided for by the corre-

sponding standards/laws in force in the country

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel MIRA 16 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel MIRA 16

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info