Bedienungsanleitung Cadel RIVER IDROTECH 24 H2O (Seite 24 von 40) (Englisch)

815230

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

RIVER IDROTECH 18 - 24 - 24H2O

10.9 BLACKOUT WITH THE BOILER ON

In the event of a power cut (BLACKOUT) the boiler behaves as follows:

• Blackout below 10”: it returns to its operation in progress;

• In the event of a power cut that lasts over 10” with the boiler on or in the start-up stage, when the boiler is powered again it

goes back to the previous operating condition with the following procedure:

1) It performs a cooling phase to the maximum.

2) Performs a new ignition.

During stage 1 the panel displays ON BLACK OUT.

During stage 2 the panel displays Start-up.

If during stage 1 the boiler receives commands from the panel and thus carried out manually by the user, then the boiler stops

executing the blackout recovery status and proceeds to restart or shutdown as requested by the command.

10.10 CONTACT THERMOSTAT IN THE BOILER

If the temperature exceeds the preset safety level, it immediately shuts down boiler operation.

10.11 WATER TEMPERATURE PROBE

If the water temperature approaches the shutdown temperature (85°C) the probe makes the boiler perform the “OFF Stand-by”

automatic shutdown.

10.12 ANTIFREEZE FUNCTION

If the probe in the boiler detects a water temperature of less than 5°C, the circulation pump is automatically activated to prevent

the system from freezing.

10.13 PUMP ANTISEIZURE FUNCTION

If the pump is not used for prolonged periods, it is activated periodically for a few seconds to prevent it from seizing up.

TAMPERING WITH THE SAFETY DEVICES IS PROHIBITED

If the product is NOT used as described in this instruction manual, the manufacturer declines all liability for

any damage caused to persons and property. The manufacturer furthermore refuses to accept responsibility

for damage to persons and property arising from the failure to observe all the rules contained in the manual

and in particular:

• All the necessary measures and/or precautions must be adopted when performing maintenance, cleaning

and repairs.

• Do not tamper with the safety devices.

• Do not remove the safety devices.

• Connect the product to an efficient smoke expulsion system.

• Verify that the room in which the appliance will be installed is adequately ventilated.

The product can be started-up and the automatic function of the probe restored only after having eliminated

the cause that triggered the safety system. This manual will help you understand which anomaly has occur-

red, and explain how to intervene according to the alarm message displayed on the appliance.

10.14 CLEANER BLOCKED

If the burn pot grid does not close correctly, the alarm A23 is triggered. Clean the burn pot. Check that there are no pellets stuck

between grid and burn pot. (see Fig. 19). Break up the pellets using a pointed tool (see Fig. 20). Clear the alarm and switch the

stove back on.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel RIVER IDROTECH 24 H2O Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel RIVER IDROTECH 24 H2O

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info