Bedienungsanleitung Cadel ZEN AIRTIGHT (Seite 28 von 36) (Englisch)

814938

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

ZEFIRO - ZEN Airtight

12.4 ELECTRICAL SAFETY

The product is protected against sudden current surges by a main fuse in the power supply panel on the rear part of the product.

Other fuses that protect the electronic boards are found on the latter.

12.5 SMOKE FAN

If the fan stops, the electronic board promptly shuts off the pellets supply and an alarm message is displayed.

12.6 GEAR MOTOR

If the gear motor stops, the boiler will continue to run until the flame goes out due to lack of fuel and until a minimum level of

cooling is reached.

12.7 TEMPORARY POWER CUT

If the power cut lasts less than 10” the boiler returns to its previous operating status; if it lasts more it carries out a cooling/restart

cycle.

12.8 FAILED STARTUP

If during ignition no flame develops, the boiler will go into alarm condition.

12.9 BLACKOUT WITH THE BOILER ON

In the event of a power cut (BLACKOUT) the boiler behaves as follows:

• Blackout below 10”: it returns to its operation in progress;

• In the event of a power cut that lasts over 10” with the boiler on or in the start-up stage, when the boiler is powered again it

goes back to the previous operating condition with the following procedure:

1) It performs a cooling phase to the maximum.

2) Performs a new ignition.

During stage 1 the panel displays ON BLACK OUT.

During stage 2 the panel displays Start-up.

If during stage 1 the boiler receives commands from the panel and thus carried out manually by the user, then the boiler stops

executing the blackout recovery status and proceeds to restart or shutdown as requested by the command.

12.10 ALARM ALERTS

Whenever an operating condition other than that designed for the regular operation of the boiler occurs, there is an alarm condi-

tion.

The control panel gives information on the reason of the alarm in progress.

PANEL ALERT TYPE OF PROBLEM SOLUTION

A01 The fire does not ignite.

Check whether the brazier is clean / level of pellets in the

hopper.

Check pellet level in the tank.

Check that the burning pot is correctly positioned in its

case and does not contain deposits or unburned material.

Check that the pellet cover and the fire door are correctly

closed.

Clogged flue

Damaged ignition resistance

A02 The fire goes off abnormally. Check the level of pellets in the hopper.

A03 Thermostat

alarms

The temperature of the pellets hopper or the

water temperature exceed the envisioned safety

threshold.

Wait for the cooling stage to end, cancel the alarm and

restart the boiler setting the fuel loading at minimum

(SETTINGS menu - Pellet Recipe).

Check that dust does not clog the aeration grid on the stove

back.

If the alarm persists, contact the service centre. Check if the

room fan works properly (if present).

A04 Smoke overheating. The set smoke threshold has been exceeded. Reduce pellets

loading (SETTINGS menu - Pellet Recipe).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel ZEN AIRTIGHT Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel ZEN AIRTIGHT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info