Bedienungsanleitung Caldera Fantasy Spa 2020 (Seite 22 von 24) (Englisch)

809119

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

TROUBLESHOOTING PROCEDURES

In the event the spa is not working the way it

should, please first review all the installation and

operating instructions in this manual and check the

message on the panel display. If you are still not

satisfied it is working properly, please follow the

appropriate troubleshooting instructions.

CAUTION! WARNING! SHOCK HAZARD!

No User Serviceable Parts.

Do not attempt service of the control box. Contact

your local Dealer for assistance. Follow all owner's

manual power connection instructions.

NO COMPONENT

OPERATION

Check the following:

1. Is there power to the spa?

2. Is the household circuit breaker tripped?

3. Is the subpanel (230V) tripped?

4. If 1 is yes and 2 and 3 are no contact your

local Dealer for assistance.

PUMP DOES NOT OPERATE,

BUT THE LIGHT DOES

Press the Jets button:

The pump operates but no water flows to jets.

Pump may not be properly primed. This can

happen after the spa is drained and refilled. Press

the Jets button several times, never leaving the

motor on for more than 5-10 seconds at-a-time

with no water coming of jets.

POOR JET ACTION

1. Press the Jets button to make certain the

pump is on.

2. Rotate all the air control valves counter-

clockwise and observe the increased jet

action.

3. Make sure the water level is half way

between top of spa and top of the gray

filter ring.

4. Check for dirty filter. Clean, if necessary.

5. Make sure all jets are in the open position

(turn counterclockwise).

WATER IS TOO HOT

1. Check desired temperature on topside

control.

2. Check for a Diagnostic Message (in

Control Panel Operation section).

OH - Overheat (spa is deactivated) DO

NOT ENTER THE WATER.

If the spa has overheated you should remove

the cover to promote heat reduction. The

spa control system should reset itself when

the water temperature reduces below 41ºC

(

106ºF)

. When the spa temperature falls

below the reset you can push any button

on the topside control to reset the control

system. If the spa will not reset, then shut

off power to the spa and contact your local

Dealer.

Under extreme and/or prolonged weather

conditions it is possible for the ambient

temperature to exceed 41°C (

106ºF)

; effecting

the water temperature of the spa and causing

it to overheat. These conditions could cause

the spa sensors to produce an OH message

and prevent the usage of your spa during

these conditions. The location of your spa

should be reconsidered to reduce the outside

temperature around the spa. For example,

you may need to prevent direct sunlight on

any surface of your spa. Regardless, do not

enter your spa if the temperature is above

40°C (

104ºF)

Should checking the above steps fail to

correct the problem, please contact your local

Dealer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Caldera Fantasy Spa 2020 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Caldera Fantasy Spa 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info