784915
29
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
Page 26
DRAINING YOUR SPA
1. Turn off all GFCI breakers in sub-panel, or main electrical panel.
2. Locate the drain valve for the spa (lower front of the spa) and
remove the drain cap. Attach the inlet of a garden hose to the drain
valve and route the outlet of the hose to an appropriate draining
area.
NOTE: Spa water with a high sanitizer level may harm plants and
grass.
3. Open the drain valve by turning the knob. The spa will drain by
gravitational flow.
IMPORTANT: All models will drain almost completely through the
drain valve. Equipment such as the jet pump and heating system
may not completely drain. Any water remaining within the plumbing
or equipment after draining will only need to be removed if the spa
is being winterized.
4. After your spa is empty, clean the shell and filter cartridge.
5. Close the drain valve and reinstall the drain cap.
6. Install new filter or clean existing with filter cleaner.
7. Follow the “START-UP PROCEDURES” to refill your spa.
PREVENTION OF FREEZING
Your spa has been designed and engineered for year-round use in
any climate. In some areas, extremely cold temperatures below -12°C
(10°F) combined with strong wind, may cause partial freezing of the jet
pump, even though the water inside the spa remains at the selected
temperature. The energy efficiency of the spa may also decrease during
these cold periods, as the heater will cycle more frequently. As an
additional precaution against partial freezing of some of the components,
the equipment compartment can be insulated with an insulating kit
(available from your local dealer). This insulating kit will also help to
maximize the spa’s energy efficiency.
NOTE: When warmer weather returns approx. 16° - 21°C (60 - 70°F),
the insulating kit must be removed to prevent overheating of the jet
pump.
WINTERIZING YOUR SPA
If you leave the spa unused for a long period of time in severely cold
weather, you should drain the spa and winterize it to avoid accidental
freezing due to a power or equipment failure.
DANGER: Use only Propylene Glycol as your anti-freeze (available
at most RV or marine supply stores). This is non-toxic. Never use an
automobile anti-freeze (Ethylene Glycol) since it is toxic!
WARNING: Failure to follow these instructions correctly can lead to
freeze damage not covered by warranty. It is strongly recommended
that you contact your local dealer to perform this service.
1. Drain your spa following the Draining Your Spa section in the
owner’s manual.
2. Remove the filter cartridge, clean and store in a dry place.
IMPORTANT: These additional instructions must be utilized when
draining and winterizing your spa in climates where the temperature
falls below 0°C (32°F). A 19 liter (5 gallon) combination (vacuum/
blower) wet/dry shop vac must be used to effectively remove water
that is trapped inside the plumbing lines.
3. Attach the vacuum hose to the vacuum side of the shop vac.
Vacuum all openings and orifices as follows:
a. Jet openings: start with the jets at the top and move
downward (if suction is coming from another jet, block off the
other jet using a large rag – this will help pull out the water that
is trapped deeper inside the main line).
b. Filter suction fittings and filter compartment.
c. Main drain outlet (it may be necessary to cover the drain grate
tightly with a rag when vacuuming the main drain to ensure
water is drawn completely from the internal plumbing system).
4. Thoroughly dry the spa shell with a clean towel.
5. Remove pump door first. Once door is removed unscrew the pump
drain plugs located on the front of the pump housing. Allow all
water to drain out. Place the drain plugs in a ziplock bag and store
near the pumps. Replace the drain plugs on Start-up.
6. Unscrew the pump unions and allow the water to drain. Loosen
and remove hose attached to circulation pump to allow any
remaining water from heater and spa to drain out. Replace
circulation pump hose once water is drained. NOTE: Tighten the
pump unions prior to filling the spa.
7. Replace the main drain cap.
8. Using a long-extension funnel, pour anti-freeze into all standpipes,
filter suction fittings, jet orifices and water feature orifices. Add
enough anti-freeze to ensure adequate protection – in many
cases, you will see the liquid in the orifice, or coming out of another
location.
CAUTION: Use only Propylene Glycol as your anti-freeze. This is
non-toxic. Never use an automobile anti-freeze (Ethylene Glycol)
since it is toxic!
9. Close the spa cover and fasten the cover tie downs. Cover the spa
cover with two pieces of plywood to evenly distribute the weight of
snow and ice. Secure a plastic sheet, or tarp, over the spa cover
and plywood.
10. Replace the equipment access door, if removed.
OPENING INSTRUCTIONS:
1. Remove plywood and plastic sheet. Open the spa cover by
unfastening the cover tie downs.
2. Follow the Start-up Procedures in the Getting Started section of
the Owner’s Manual. Do not install filters to prevent them from
exposure to the anti-freeze.
3. As part of this process, superchlorinate the spa water by adding
three teaspoons of chlorine (sodium dichlor) per 950 liters (250
gallons) of spa water into the filter compartment. This is twice the
normal amount of chlorine needed for superclorination. This extra
amount of chlorine is needed to destroy the anti-freeze.
NOTE: A defoamer may be needed to decrease the amount of
foam caused by the anti-freeze.
4. Drain your spa to ensure removal of anti-freeze. Do not drain water
on grass or plants due to excessive chlorine level.
5. After the spa has completely drained, re-install your filter and
follow the Start-up Procedures in the Getting Started section of the
Owner’s Manual.
IMPORTANT: Always keep spa covered when not in use, whether
it is empty or full.
Spa Care and Maintenance
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Caldera Paradise - serie 2021 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Caldera Paradise - serie 2021

Caldera Paradise - serie 2021 Bedienungsanleitung - Deutsch - 44 seiten

Caldera Paradise - serie 2021 Bedienungsanleitung - Holländisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info