Bedienungsanleitung Caldera Utopia serie - 2017 (Seite 13 von 44) (Englisch)

784879

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Page 10 Water Quality and Maintenance

FROG WATER CARE SYSTEM

The FROG Water Care system is comprised of the following two

products:

THE FROG MINERAL CARTRIDGE. This cartridge introduces minerals

into the spa water, inhibiting bacteria growth.

THE FROG BROMINE CARTRIDGE (BCDMH). The only recommended

sanitizer that will work in conjunction with the FROG Mineral cartridge.

It is important that in addition to regularly testing and balancing your

spa water, a weekly "shock treatment" is required. The shock treatment

quickly destroys any remaining contaminants while revitalizing the

bromine in the water.

To weekly “shock treat” your spa, we recommend that you use either

MONARCH MPS Plus or sodium dichlor (chlorine). Sodium dichlor may

be a more appropriate weekly shock for those users that experience

heavy bather load conditions.

The following optional products can be used in conjunction with the

FROG Water Care system:

MONARCH MPS PLUS NON-CHLORINE SHOCK (MPS/

Monopersulfate) is an oxidizing chemical used to prevent the buildup

of contaminants, maximize sanitizer efficiency, and improve water

clarity. When used in conjunction with the FROG system it oxidizes

particulates in the spa water.

IMPORTANT NOTE: MONARCH MPS Plus is an oxidizer, not a

sanitizer.

MONARCH CORONA DISCHARGE (CD) OZONE is a high output

ozone system and is the only ozone purification system approved for

installation in your CALDERA Spa. The MONARCH ozone system

utilizes CD technology to produce a higher concentration of ozone

than is produced by a competing chip style CD or ultraviolet light

ozone systems.

NOTE: Refer to the Start-Up instructions on page 4 of your FROG

owner's manual for start-up and operation instructions. The

owner's manual can be found with your FROG starter kit.

It is important to follow the recommended application and maintenance

programs outlined for each product’s use. If the spa is being used over

an extended period or time, such as a whole afternoon or evening,

additional sanitizer will be needed.

NOTE: The FROG Mineral Cartridge is not approved for use in

Canada.

NOTE: For Canada, if you are only using the bromine cartridge, your

bromine levels should be between 3.0 - 5.0 ppm.

FROG CARTRIDGE REPLACEMENT

INSTRUCTIONS

The FROG bromine cartridge should be replaced every 2-4 weeks,

depending on User Load. The FROG mineral cartridge should be

replaced every 4 months. When replacing the mineral cartridge, it is

highly recommended that the spa be drained and refilled at the same

time. After refilling the spa with water, balance the Total Alkalinity (TA),

Calcium Hardness (CH) and pH to the recommended levels. Shock

the spa by adding MONARCH MPS Plus non-chlorine shock shock or

sodium dichlor (chlorine).

To replace FROG

cartridges, follow these steps:

1. Turn off power to the spa.

2. Unscrew FROG cap on top edge of spa.

3. Turn handle counter-clockwise.

4. Lift cartridge holder up and out of spa.

5. Remove and discard old cartridges.

6. Turn top cap of new Mineral cartridge to setting #6 (evaluate water

in 1 week and adjust as necessary).

7. Turn top cap of new bromine cartridge to setting #6 (measure

bromine with bromine Test Strip in 1 week and adjust as

necessary).

8. Snap bromine cartridge into the bottom of holder and snap mineral

cartridge into the top.

IMPORTANT: It is important that the bromine cartridge is on

the bottom; otherwise, the bromine cartridge could dispense

prematurely.

9. Reinstall cartridge holder into spa, push down, and twist clockwise.

10. Replace FROG cap.

11. Reconnect power to the spa.

IMPORTANT NOTE: Adjust bromine cartridge setting down by one

setting each day until a residual of 1.0 - 2.0 ppm level of bromine is

established.

WARNING:

High sanitizer levels can cause discomfort to the user’s

eyes, lungs and skin. Always allow the sanitizer level to fall to the

recommended range before using the spa.

THE CALDERA SPA WATER

MAINTENANCE PROGRAM

FILLING THE SPA WITH WATER

Use the CLEAN SCREEN pre-filter to remove unwanted contaminants

such as rust, dirt, detergents, and algae from the fill water. Dissolved

metals, copper, iron, and manganese are also removed. Instructions are

included with the CLEAN SCREEN pre-filter. Always fill the spa through

the filter compartment. Do not fill your spa using water from a swimming

pool as pool

chemicals are very different from those used in a spa and

can damage your spa.

ADDING CHEMICALS TO THE WATER

All spa water chemicals, including granulated dichlor, MPS, granulated

pH increaser or decreaser, granulated total alkalinity increaser, liquid

stain and scale inhibitor, and liquid defoamer must always be added

directly into the filter compartment while the jet pump is running in its

high speed mode, and it must run for a minimum of ten minutes with the

cover off. Use the Clean button/feature to ensure that the chemicals are

properly mixed when adding.

BUILDING A SANITIZER ROUTINE

During the first month of ownership, measure the sanitizer residual

daily in order to establish a baseline of sanitizer needed vs. spa usage.

Sanitizer needed is the amount of Free Available Chlorine needed to

accommodate the number of users and their combined usage time. For

example, two spa users for twenty minutes every day creates regular

demand on the sanitizer that is used to determine how much sanitizer

to add in order to maintain the proper residual. If the usage pattern

increases dramatically with invited guests, the amount and frequency of

sanitizer required increases dramatically.

Caldera Utopia serie - 2017 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Caldera Utopia serie - 2017

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info