Bedienungsanleitung Caldera Vacanza - serie 2019 (Seite 34 von 40) (Englisch)

784922

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

7. Close the spa cover and fasten the cover tie downs. Cover the spa

cover with two pieces of plywood to evenly distribute the weight of

snow and ice. Secure a plastic sheet, or tarp, over the spa cover

and plywood.

8. Replace the equipment access door, if removed.

OPENING INSTRUCTIONS:

1. Remove plywood and plastic sheet. Open the spa cover by

unfastening the cover tie downs.

2. Follow the Start-up and Refill Procedures in the Operating

Instructions section of the Owner’s Manual. Do not install filters to

prevent them from exposure to the anti-freeze.

3. As part of this process, superchlorinate the spa water by adding

three teaspoons of chlorine (sodium dichlor) per 950 liters (250

gallons) of spa water into the filter compartment. This is twice the

normal amount of chlorine needed for superclorination. This extra

amount of chlorine is needed to destroy the anti-freeze.

NOTE: A defoamer may be needed to decrease the amount of foam

caused by the anti-freeze.

4. Drain your spa to ensure removal of anti-freeze. Do not drain water

on grass or plants due to excessive chlorine level.

5. After the spa has completely drained, re-install your filter and follow

the Start-up and Refill Procedures in the Operating Instructions

section of the Owner’s Manual.

IMPORTANT: Always keep spa covered when not in use, whether it is

empty or full.

FILTER SYSTEM

The filter lid on the spa is NOT designed to support heavy weight loads

and should not be used as a seat. In extreme cases, the lid could crack

and break. This occurrence is considered abuse and is not covered under

the warranty.

CALDERA spas are equipped with one filter cartridge, sized to meet the

needs of the jet pump system.

At least once a week, check and clean the skimmer basket and weir to

ensure proper filter flow. Remove leaves, foreign matter, and debris. It is

very important to keep your spa filter cartridge clean and free of particles

to ensure proper water flow. A clean filter permits the hydrotherapy

system to function properly and also allows more efficient filter cycles.

Depending on how frequently your spa is used, we recommend cleaning

the spa filter cartridge every four weeks. If this is not done, the filter may

clog and restrict water flow, which causes improper filtration and poor jet

performance.

WARNING: To reduce the risk of injury to persons using the spa, DO

NOT remove the suction fittings (filter standpipes) located in the filter

compartment and do not sit on the filter lid, in extreme cases the lid could

crack and break. This occurrence is considered abuse and is not covered

under warranty.

SECONDARY SUCTION SCREEN

Located in the foot well of your spa are three secondary suction screens.

The screen is used as a filter to prevent dirt from circulating through the

system.

WARNING: Do not use the spa with the suction screens removed.

FILTER CARTRIDGES REMOVAL &

CLEANING (ALL MODELS EXCEPT

AVENTINE)

1. Disconnect the spa from the power supply by turning the power to

the spa OFF.

2. Remove any floating items from within the filter compartment.

3. Turn the filter retainer handle (located on the top of the filter cartridge)

counterclockwise until the retainer can be removed from the filter

standpipe.

4. Remove the filter retainer, cover and cartridge.

SERVICE NOTE: Never remove the filter standpipe when debris is present

in the filter compartment. Debris may find its way into the internal plumbing

which may result in blockage. NEVER REMOVE SUCTION FITTINGS!

5. Always clean the filter using a filter degreaser, such as Filter

Cleaner, to remove mineral and oil build-up. Simply soak the filter in

the degreaser according to the package directions, then place the

filter on a clean surface and spray until clean using a garden hose.

It may be necessary to rotate the filter while spraying to remove any

debris lodged between the filter pleats.

6. To reinstall the filter cartridge, reverse the order of steps in which

it was removed. Do not overtighten.

WARNING: Do not use the spa with the filter cartridge, or filter

standpipe removed!

FILTER

CARTRIDGE

STANDPIPE

RETAINER

HANDLE

ION SANITIZER

INSIDE STANDPIPE

FILTER

COVER

Spa Care and Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Caldera Vacanza - serie 2019 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Caldera Vacanza - serie 2019

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info