Bedienungsanleitung Caldera Vacanza - serie 2022 (Seite 31 von 40) (Englisch)

784919

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Water Quality and Maintenance

MANUAL CHLORINE (SODIUM DICHLOR)

Watkins Wellness recommends the use of

Concentrated Chlorinating

Granules (sodium dichlor) for sanitizing the water. Sodium dichlor is

preferred because it is totally soluble, dissolves quickly, and is nearly pH

neutral. The recommended Free Available

Chlorine (FAC), the amount of

available chlorine sanitize the spa, 3.0-5.0 ppm.

If the FAC is too low: Increase the FAC by adding granulated sodium

dichlor.

If the FAC is too high: Allow time to pass and the FAC level will

naturally drop over time.

If the spa smells of chlorine: super chlorinate or shock the spa FAC

chlorine does not have an odor whereas combined spent chlorine

(chloramines) has a strong chlorine odor that can be eliminated by

shocking the water.

IMPORTANT: There are several forms of stabilized chlorine available for

use in spas and swimming pools. It is extremely important to choose one

specifically designed for spas. Use of an incorrect product such as tri-

chlor which has a very low pH (2.6) and dissolves too quickly in hot water,

results in extremely high levels of chlorine that WILL cause damage to

your spa. Use of a compressed bromine/chlorine or unapproved sanitizer

WILL damage your spa and is specifically not covered under the terms of

the limited warranty.

Water chemistry damage is not covered by the warranty. The chemical

levels and water quality in the spa are under your direct control. With

proper basic care, the spa will provide many years of hot water relaxation.

If you are unsure about any chemical or its usage in the spa, contact your

Authorized Dealer, or Watkins Wellness.

DO:

Add all chemicals slowly into the filter compartment with the jet pump

operating for ten minutes.

Use special care if using baking soda to clean either the interior or

exterior plastic surfaces.

IMPORTANT: Watkins Wellness DOES NOT recommend the use of any

floating chemical dispenser. Damage to the spa shell or components

caused by a floating chemical dispenser is specifically not covered under

the terms of the limited warranty. Floating dispensers can become

trapped in one area and cause an over-sanitization or release large

chunks of sanitizer that very quickly chemically burn the shell and cover.

DON'T:

Use compressed sanitizers.

Use a floater type sanitization system as a low or no maintenance

solution to your spa maintenance program.

Use a sanitizer which is not designed for spas.

Use swimming pool (muriatic) acid to lower pH.

Broadcast or sprinkle the chemicals onto the water surface. This

method may cause chemically-induced spa surface blistering

(chemical abuse).

OZONE MAINTENANCE (OPTIONAL)

If Reduced or no ozone bubbles are coming from the heater return

(clogged ozone injector) or no ozone, clean the injector:

DANGER: Nitric acid accumulates in the air lines of the ozonator

and injector, and will cause severe chemical burns if direct skin contact is

made. Always wear protective gloves, glasses and clothing when working

on the ozonator or injector lines. To prevent inhalation or ingestion of the

nitric acid, DO NOT blow or inhale with your mouth to any of the

adapters, fittings or tubing of the ozonator or injector air lines.

1. Place 0.5 liter of white vinegar into a cup or bucket.

2. Carefully loosen the long tubing attached to the bottom of the

ozonator, located in the equipment compartment.

3. Place the end of the tubing into the vinegar, making certain that the

end of the tubing sits at the bottom of the container.

4. Run the spa until all 0.5 liter of the vinegar are gone. This should

allow

an ample flow of vinegar to be run through the injector and clear

the blockage.

5. Reinstall the tubing to the bottom of the ozonator.

VACATION WATER CARE

INSTRUCTIONS

If you plan to be away from home, follow these instructions to ensure that

the water quality of your spa is maintained:

SHORT TIME PERIODS (3-5 DAYS)

1. Adjust the pH by following the instructions outlined in the Water

Quality and Maintenance section.

2. Sanitize the water by following the shock procedures also listed in the

Water Quality and Maintenance section.

3. Lock your cover in place using the coverlocks.

4. Upon your return, sanitize the water by following the shock

procedures, and balance the pH.

LONG TIME PERIODS (5-14 DAYS)

Prior to leaving:

1. At least one day before you leave, set the temperature to its lowest

level. This setting should represent an approximate water temperature

of 27°C (80°F)

IMPORTANT: Spa water oxidizers such as sodium dichlor (chlorine)

maintain their level of effectiveness substantially longer in warm water

27°C (

80°F

)

than in hot water 38°C - 40°C (101°F to 104°F).

2. Adjust the pH as required. Sanitize the water by following the shock

procedures.

Upon your return:

3. Sanitize the water by following the shock procedures. Return the set

temperature to its original setting. The spa water will be safe for you

to use once the Free Available Chlorine residual level has dropped

below 5.0 ppm.

IMPORTANT: If you will not be using your spa for an extended period

of time (in excess of 14 days) and an outside maintenance service (or

neighbor) is not available to assist with the water maintenance, draining

or winterizing of the spa is recommended.

Caldera Vacanza - serie 2022 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Caldera Vacanza - serie 2022

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info