Bedienungsanleitung Caldera Vacanza-serie 2023 (Seite 7 von 40) (Englisch)

809115

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

InStallatIon

SITE PREPARATION

You probably have a spot picked out for your new spa, whether it’s indoors

or outdoors, on a patio or on a deck. Please make sure you check the

following:

• Always put your spa on a structurally sound, level surface. A filled

spa can weigh a great deal. Make certain that the location you

choose can support the weight of your filled spa.

• Don’t forget to level your spa before filling it. (See the Spa Leveling

Preparation.)

• Locate your equipment compartment, which houses all of the

electrical components, in a place where water will drain away from

it. Allowing water into the equipment compartment can damage the

electronics, or may result in tripping your house’s circuit breaker.

• Leave yourself easy access to the circuit breaker in the subpanel.

• Leave access to the equipment compartment for periodic spa care

and maintenance.

WARNING: Damage to the spa’s equipment compartment

components or internal plumbing as a result of rodent

infestation is NOT covered under your warranty!

OUTDOOR AND PATIO INSTALLATION

No matter where you install your new spa, it’s important that you have a

solid foundation to support it. Structural damage to the spa, resulting from

incorrect installation, or placement on an inadequate foundation, is not

covered under the spa’s limited warranty.

If you install the spa outdoors, we recommend a reinforced concrete pad

at least 10 cm (four inches) thick. The reinforcing rod or mesh in the pad

should be attached to a bond wire.

DECK INSTALLATION

To be certain your deck can support your spa, you must know the deck’s

maximum load capacity. Consult a qualified building contractor or structural

engineer. To find the weight of your spa, its contents and occupants, refer

to the Spa Specification chart on back cover. This weight per square foot

must not exceed the structure’s rated capacity, or serious structural damage

could result.

INDOOR/BASEMENT INSTALLATION

Be aware of some special requirements if you place your spa indoors.

Water will accumulate around the spa, so flooring materials must provide

a good grip when wet. Proper drainage is essential to prevent a build-

up of water around the spa. When building a new room for the spa it is

recommended that a floor drain be installed. The humidity will naturally

increase with the spa indoors. Water may get into woodwork and produce

dry rot, mildew, or other problems. Check for airborne moisture’s effects

on exposed wood, paper, etc. in the room. To minimize these effects, it is

best to provide plenty of ventilation to the spa area. An architect can help to

determine if more ventilation must be installed.

CALDERA spas are equipped with a jet pump shroud to remove excessive

heat from the equipment compartment. Find this vent and be sure the vent

is not blocked by anything, including carpeting.

Your CALDERA dealer can help you with local information such as zoning

regulations and building codes.

WARNING: Please keep the area around your spa well ventilated

when it is installed indoors or in a confined area.

Inadequate ventilation around the spa could cause a build-up of a higher-

than-normal concentration of spa chemicals and/or bacterial fragments.

These dispersed spa chemicals and/or bacterial fragments can be

inhaled, and may result in breathing difficulties or lung damage in certain

people suffering from a compromised immune system or respiratory

infection. If you or other bathers are affected by this condition, please

seek medical attention as soon as possible.

In addition to the above, properly clean and maintain your spa as follows:

• Follow all procedures in this owner’s manual and printed

instructions on all water care (chemical) products packaging.

• Test the water regularly to ensure proper levels of sanitizers, pH,

and other water care requirements.

• Drain, clean, and refill your spa with fresh water on a regular

schedule, and in accordance with this owner’s manual.

• Clean the filter at least once per month.

• Check to make sure you have proper circulation throughout your

spa water system.

• Have spa users bathe before entering the spa water.

SPA LEVELING PREPARATION

Concrete sloped at 1.5 cm per 3 m (.5" per 10') is preferred so that rain

water and water spillover will run off and not puddle underneath the spa

(water under the spa for long periods of time may cause the wood to

deteriorate). Other options are brick, stepping stone, or blocks.

It is important to note that soft surfaces, even when stepping stones are

used to evenly distribute the weight of the spa, will have a tendency to

settle, thus resulting in an unleveled spa.

NOTE: Placing the spa on grass or dirt may increase the amount of debris

which is inadvertently brought into the spa water and may cause harm to

your equipment as well as the spa surface, which is not covered under

warranty.

Installation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Caldera Vacanza-serie 2023 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Caldera Vacanza-serie 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info