Bedienungsanleitung Caliber CA4050 (Seite 3 von 24) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

536998

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

      



        

• Connect the RCA-outputs of your radio to the RCA input terminals of the amplifier. Take good

care that you connect the Right output of your radio to a Right input of your amplifier, and that

you connect the Left output of your radio to a Left input of your amplifier.

             

• The Caliber amplifiers have Stereo/Bridgeable Tri-Mode speaker output terminals. You can

connect the speakers to each channel in stereo mode, and simultaneously connect a sub-woofer

to the speaker terminal in a bridged mode.

• Pay attention in connecting your speakers and/or sub-woofers. Be sure to observe correct

speaker output connections for front, rear and their polarity.

• In the stereo mode, connect the right speaker output to the right speaker and the left to the

left.

Connect the positive (+) output to the positive (+) speaker terminal and the negative (-) output

to the negative (-) speakerterminal.

• In the bridged mode connect the left (+) positive to the positive speaker terminal and the right

(-) negative to the negative speaker terminal.

• Do not use the negative speaker output commonly for left and right speakers (common

ground). Improper polarity causes a loss of bass response.

• Never connect the negative speaker output to the chassis of your vehicle. This can cause severe

damage to your Car Audio System.

                    

• Put the input level adjustment knob to the minimum.

• Put the volume of your radio to 3/4 of the maximum.

• Adjust the Bass Boost to your personal sound.

• Now adjust the input level of the front channel. Slowly turn up the input level and listen care-

fully untill you hear the amplifier begin to distort. A Caliber Amplifier “clips” very softly, so this

can sometimes be a difficult adjustment. If you have turned up the Bass Boost to much, the

amplifier will start clipping immediatly. In that case you must turn back the Bass Boost and start

adjusting the inputlevel again. You will hear that the Bass you wanted can be required in this way.

               

Due to the complexity of our products, we strongly recommend that this amplifier is installed

by your authorized Caliber dealer. If properly installed by your dealer we provide a warranty for

12 months from the date of purchase.

If you install this amplifier yourself, we wish you lots of fun and succes in doing so. If you follow

our guidelines, you’ll get the best result. Our warranty, however, will be limited to and not exceed

30 days from the date of purchase.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Caliber CA4050 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info