165946

Caliber mcc 110 Seite 3

3
Zoom out
Zoom in
Vorherige Seite
1/21
Nächste Seite
NOTE:
You must use 4 ohms impedance of speaker in your speaker system to reduce the distortion
during high volume level.
INSTALLATION
1. Choose the mounting location that will not interfere the normal driving function of the driver.
2.Avoid installing the unit in a place where it would be subjected to dirt, dust, damp, high
temperature and excessive vibration.
3. Please install appendixes provided by the manufacturer.
PRECAUTIONS AND MAINTENANCE
1.This unit is designed for negative ground operation only.The equipment can be used safely,
if the negative terminal of the battery is connected to the vehicle metal work.
2.Do not use speakers of impedance less than 4 ohms; and allow the speaker wires to be
shorted together when the unit is switched on. Otherwise it may overload or burn out
the power amplifier stage.
3.If the car interior is extremely hot, as after being parked in the sun, do not use the player
until the car has been driven for a while to cool off the interior.
4.Ta ke care of your tape cassette to preserve the quality of the recordings. Do not expose
them to direct sunlight. Store them in a place protected from dirt and dust and
avoid handing with greasy or oily hands.Also, keep the away from magnets, and
motors of the permanent magnet type.
5.It is not advisable to use cassette tapes longer than C-60(30 minutes per side) in
automobile players, since the tape is too thin and tends to become easily entangled.
Always remove cartridge from your tape player as soon as play is finished.
6.The capstan and tape head should be cleaned about once every six months with a soft cloth or cot-
ton-wool swab, moistened with alcohol.
This will serve to maintain the richness and clarity of sound, and prevent loss of volume. Do not use a
screwdriver, or ferrous metal rod, in carrying out the above cleaning. See illustration.
7.A loosely wound cassette tape will get damaged. Prior to using such tape, tighten it in a manner as
guided by Fig2.A carelessly wound cassette tape will cause unnecessary pressure on the tape resul-
ting in the cassette springing out while the tape is running. For prevention, rewind the tape through
fast forwarding or rewinding.
GB 4
USER MANUAL
2).Temporary switch over to an EON linked station when EON detects a traffic announcement
on the other program.
3).If the volume level was under the threshold point, it will be raised to the threshold point. If
the volume level was set to more than the threshold point (min.TA volume level), it will be set
to the last level.
When pressed long,TA SEEK mode on or off, and TPST ON/OFF will be displayed on LCD.
When the newly tuned station does not receive TP information for 5 seconds, the radio retunes
to the next station which has not got the same station(PI) as the last station, but does have the
TP information.
In TA seek mode, the current station can be changed to a completely different station because
the unit searches TP station when the field strength of the current station is very weak, or when
the current station has no TP signal.
15.TUNE UP OR DOWN BUTTONS
In RADIO mode, press ^ or v button shortly and repeatedly to manually tune up or down for
the desired radio station. Press ^ or v button for more than 2 seconds to automatically tune up or
down for the radio station of a strong signal.
16.EJECT KEY
At TAPE mode, push this key to stop tape playing and eject the tape from the cassette compartment.
17.CASSETTE COMPARTMENT
18. MUTE
19. STEREO/MONO
SPECIFICATIONS
Power Supply Main Unit DC 13.8 Volts. Negative Ground
Current consumption 10A MAX
Maximum Output Power 35W X 4
Unit Dimensions 178(W) x 150(D) x 50(H)
FM SECTION
Frequency Range 87.5MHz - 108MHz
CAUTION: Do not install the detachable panel before connecting the unit.
1.The unit is designed for negative terminal of the battery which is connected to the vehicle
metal. Please make sure this is connected before starting installation.
2. If the car interior is extremely hot, as after being parked in the sun, do not use the player until
the car has been driven for a while to cool off the interior.
GB 3
USER MANUAL
REL
M1.TAPPING SCREW
M2. PLAIN WASHER
M3. SPRING WASHER
M4. HEX NUT
M5. HEX BOLT
M6. SLIDE BRACKET HOUSING
M7. CONSOLE
M8. DASH BOARD
M9. METAL MOUNTING STRAP
M10. KEY PLATE
2.
MCC_110manualOUTLINES 18-03-2005 11:47 Pagina 3
3 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Caliber mcc 110 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info