ENGLISH
7
Cause
The car ignition switch is not on
The fuse is blown
Presence of disc inside the player
Inserting the disc in reverse direction
The disc is extremely dirty or defective
Temperature inside the car is too high
Condensation
Volume is in minimum
Wiring is not properly connected
The installation angle is more than 30 degrees
The disc is extremely dirty or defective
The built-in microcomputer
is not operating properly due to noise
The antenna cable is not connected
The signals are too weak
Mechanism error
Servo Focus error
Solution
If the power supply is properly connected to the car
accessory terminal,switch the ignition key to "ACC"
Replace the fuse
Remove the disc in the player, then insert a new one
Insert the compact disc with the label facing upward
Clean the disc or try to play a new one
Cool off or until the ambient temperature
returns to normal
Leave the player off for an hour, then try again
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle less than 30 degrees
Clean the compact disc, then try to play a new one
Front panel is not properly fixed into its place
Press the RESET button.
Insert the antenna cable firmly
Select a station manually
Press the reset button to correct the problem. If the
error code does not disappear, consult your nearest serv-
ice dealer.
Press the reset button to correct the problem. If the
error code does not disappear, consult your nearest serv-
ice dealer.
Problem
No power
Disc cannot be
loaded or ejected
No sound
Sound skips
The operation keys do not work
The radio does not work
Error 1
Error 2
TROUBLESHOOTING
Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer.