781509
4
Zoom out
Zoom in
Vorherige Seite
1/11
Nächste Seite
ENGLISH
7
ENGLISH
6
2. Connect the red wire of control box to positive pole of reversing light,
black wire to the negative, red power wire of camera to the positive
pole of reversing light; (ref: installation diagram).
3. Connect video wire following the general installation diagram.
4. Put the car into reverse gear, the rear camera signal enters control box
and will be output via VOUT after superposing characters.Then there
should be a image with a white dot on the display, indicating parking
sensor entered normal detecting.
Test:A.If the display does not show any image, please check whether
the polarity of the power is correct, the cables are correctly
connected, the voltage is beyond regulated, or the plug on the
display is well connected.
B.If the display is in disorder, please exit and put the car into
reverse gear again. If the problems still could not be solved, the
control box could be deemed defective which needs a entire
replacement.
5. If a person stand right before the sensors within 1m, he/she should be
detected normaly
Test:A.Insert one sensor into control box, if the horn gives continuous
sound and show “0.0”, please check wheter it detected rear
outshoot (such as registration mark, spare wheel, bumper, etc.), the
sensor is fixed too tight or near to some strong interference
sources (such as exhaust pipe, other wires).
B.If it shows distance figure on display without any obstruction
around the sensor, it may detect the ground, please check the
positon and direction of sensor;
C.If the problem still can not be removed, the whole system should
be replaced.
Note:A.This display could be interchangeable, but the connection
between the sensor and control box or the joint end is unique.
B.The display program: it displays “0.0” and gives continuous sound
when the system detects something in the distance range of
0.0~0.2m; the alarm will stop for 1 more second at the distance of
0.5m. Please pay attention to the above note while testing.
NOTE
1.The car must be in power-off during the installation.
2. It’s performance may be affected in following situation: heavy rain, fravel
road, bumpy road, sloping road, and bush, very cold, hot or moist
weather, or the sensor is covered by ice, mud, etc.
3. Switches among ultrasonic and electric wave, DC and AC may effect its
performance.
4.The sensors should be installed appropriate loose or tight.
5. It’s performance may be effected if the sensors are fixed on metallic
bumper.
6.Avoid installing the digital control box in places of great interference,
such as vent-pipe, wiring nearby.
7.Test the system to make sure it works normally before using
8.This system is a reversing aid and the manufacturer will make no
responsibility for any accident after the kit is installed.
Control box
Camera
Horn
Horn
Control box
Camera
Sensor
Sensor
Reverse light
This system excludes display, a display
should be outer connected in addition.
GENERAL INSTALLATION DIAGRAM
PARK 500 manual werkdoc.qxd 28-11-2007 08:47 Pagina 6
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Caliber Park 500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info