Pressing the Select left or right buttons on the
keypad allows you to rotate through all six sources
as default. However, it is possible to allow the
addition of one or two local sources by accessing
Local source selection mode. To enter this mode
press the Volume up button simultaneously with
the Power button for four seconds; the LED
display will then scroll through the sequence
shown in the illustration and described as follows:
After holding both buttons down for a short
period, LED 2 will light indicating that Sources
1–6 (default) are available for selection.
Continuing to hold both keys down will light LED 3
indicating that Sources 1–6 + Local source 1
mode is available for selection.
Continuing to hold both buttons will light LED 4 -
indicating that Sources 1–6 + Local source 1 +
Local source 2 mode is available for selection.
Continuing to hold Volume up and Power buttons will light LED 5, to indicate
that Off mode is available for selection, and no source will be selected.
To select these modes, wait till the corresponding LED is lit and then release
Power and Volume up buttons.
Note: If no adjustment is made the system will automatically go back to volume
adjustment after two seconds. If “Standard A-BUS/Incognito Ready” mode is
selected on the Mode switch, the BK10 will only rotate round the main 6
sources.
23 4 5
BK10 Table-top keypad
Incognito table-top keypad 17
