AM10
9
ENGLISH
Technical specifications
Power output 35 watts (into 8Ω)
THD (unweighted) <0.01% @ 1kHz, 80% of rated power
<0.15% 20Hz - 20kHz, 80% of rated power
Frequency response (-3dB) 5Hz - 50kHz
S/N ratio (ref 1W) >82dB (unweighted)
Input impedances 47k ohms
Power Amp damping factor >50
Max. power consumption 260W
Bass/Treble controls Shelving, ultimate boost/cut
+/- 10dB @ 100Hz and 10kHz
Dimensions 76 x 430 x 340mm
(3.0 x 16.9 x 13.4”)
Weight 5.6kg (12.3lbs)
Troubleshooting
There is no power
Ensure the AC power cord is connected securely.
Ensure the plug is fully inserted into the wall socket and is switched on.
Check fuse in the mains plug or adaptor.
Check the power is on at the front of the unit.
There is no sound
Check the correct input is selected.
Check that the speakers are connected correctly.
Check the unit is not in mute mode.
The sound is distorted
Check speaker connections.
There is a hum coming from the speaker
Ensure that all cable connections are secure, particularly ground/shield
connections for turntables.
There is unwanted background noise and interference
Move the unit away from other electrical equipment that is likely to cause
interference.
Ensure that all cable connections are secure, particularly ground/shield
connections for turntables.
The remote handset will not function
Check that the batteries have not expired.
Ensure that nothing is blocking the remote sensor.
In the event that the above solutions do not remedy your problem, please
consult our frequently asked questions (FAQ) section on our website:
www.cambridge-audio.com/sts/faqs
For all servicing, in or out of warranty, please contact your dealer.
After making any connections to your unit, activate the Topaz AM10 by
pressing the On/Off button on the front of the unit.
Setting the source
Press the Source button on the front of the unit corresponding to your
desired source. Alternatively, you may use the appropriate button on the
remote control.
Adjusting the volume
Use either the Volume Up/Down buttons on the remote control, or the
Volume control on the front of your unit system to change the volume
level. The newly selected level will be indicated briefly on the front display.
The volume is displayed in minus dB where 0dB is the highest level.
A progressively larger negative number indicates the volume is being
reduced.
Adjusting the audio settings
Adjustments to the bass, treble and balance can be made as follows:
1. To enter the audio menu. Press either the Menu button on the front of
the unit or on the remote control.
2. Step through the available settings by pressing the Menu button. The
settings available are in order Bass, Treble and Balance.
3. When you wish to make an adjustment for bass, treble or balance,
simply rotate the Volume control or use the Volume control buttons on
the remote control.
4. To exit, wait for five seconds, until the unit returns to normal mode.
Operating instructions
