Bedienungsanleitung Camina-Schmid Ekko-W (Seite 9 von 44) (Englisch)

810637

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Safety

1.8 Correct and proper use

1.8.1 Fireplace inserts

The ﬁreplace inserts are part-time operation ﬁreplaces in

compliance with EN 13229. They may only be operated

as individual room heaters (stoves). Other uses – such as

their use as the sole heating system for all rooms – are not

permitted.

The ﬁreplace inserts are used to heat the room air. They are

primarily used for the heating of single rooms and may only

be operated within these rooms.

1.8.2 Boiler

Hydronic ﬁreplace inserts are equipped with a water heat

exchanger. The latter is used to heat up ‘hot water’ and may

only be operated when connected to the building’s heating

circuit. Other uses – for instance as an instantaneous water

heater to heat domestic water – are not permitted. Other

uses – such as their use as the sole heating system for all

rooms – are also not permitted.

1.8.3 Flue gas heat exchanger

The ﬁreplace inserts are equipped with a water heat

exchanger, which is only suitable for operation in sealed hot

water heating systems with pump circulation.

1.8.4 Fuels

The ﬁreplace inserts may only be operated with natural, air-

dried logs with a maximum residual moisture content of 20%

or pellets made of natural wood according to ISO 17225-3.

The use of other fuels is not permitted.

1.8.5 Combustion air supply

The presence of oxygen is required for the combustion

process. The ﬁreplace inserts are designed and constructed

as room air-dependent ﬁreplaces. Supply air is fed to the unit

through openings in the lower part of the appliance. Ensure

an adequate combustion air supply to ensure an optimum

combustion process when designing, installing and operating

the ﬁreplace inserts.

Refer to chapter 12 “Technical data” for information on the

combustion air requirement of the individual appliance types.

1.8.6 Closed operation

Only operate ﬁreplace inserts with the door closed. When

operating the ﬁreplace insert, only open the door brieﬂy to

load and insert fuel.

Keep all doors and adjustment devices closed when ﬁreplace

inserts are not in operation.

1.8.7 More than one ﬁreplace is connected to

the same chimney

Refer to chapter 12 “Technical data” regarding the suitability

of the ﬁreplace inserts if more than one ﬁreplace is

connected to the same chimney. In this case, the information

regarding closed operation applies in particular. If all the

doors and adjustment devices are open, it can lead to

functional faults on other ﬁreplaces connected to the

chimney.

1.8.8 Cleaning, maintenance and

troubleshooting

Comply with cleaning and maintenance intervals and

immediately rectify faults. These measures are part of

correct and proper use!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Camina-Schmid Ekko-W Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Camina-Schmid Ekko-W

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info