Bedienungsanleitung Camina-Schmid Lina (Seite 21 von 40) (Englisch)

810632

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Operation

5.5.2 Combustion stage 2: Power phase

View “from above”

Fig. 25: “Combustion air” lever – Position 2

“Combustion air” lever – Position 2:

This setting throttles the supply of air and extends the

combustion time. Do not open the door of the appliance

in this phase as this interrupts combustion and has

asigniﬁcant impact on the chimney eect. However, should

the door of the appliance nevertheless need to be opened,

we would recommend initially only opening it asmall gap –

and leaving it like this – until the system has calmed down.

Then the door can be slowly and carefully opened further.

The “combustion air control half-open” positions

are basic recommendations. However, they should

be adapted to local conditions and to the volume of

wood used to prevent incomplete combustion.

5.5.3 Combustion stage 3: Ember phase

View “from above”

Fig. 26: “Combustion air” lever – Position 3

“Combustion air” lever – Position 3:

The air supply can be throttled when the combustion cycle

is ﬁnished and no more ﬂames are visible. The rapid cooling

down of the ﬁreplace and the living space by the ﬂue liner is

prevented in this position of the combustion lever. afurther

heating process now needs to be started beginning with phase

1. The combustion lever is also moved to this position when

the ﬁreplace insert is not in use.

5.6 Combustion on ash grate

The wood rests on the ash grate with appliances with an ash

grate. The ash is collected in aash box underneath, which

can be removed from the appliance. After cleaning, return

the ash box to the appliance.

Refer to chapter 7.1.3 “Removing ash” for the procedure.

5.7 Fireplace insert becomes too hot

The ﬁreplace insert can overheat by the addition of too much

wood.

 Do not attempt to extinguish the ﬁre.

 Do not remove burning fuel from the ﬁre box.

 Slightly close the “combustion air” lever (between

position 2 and position 3) to reduce the ﬂame (heat), but

on no account fully close the supply of air.

 Open all windows to distribute additional heat.

 Open any closed air grilles.

 Only call the ﬁre service if smoke or ﬁre escapes.

Reduce the volume of logs with the next combus-

tion.

5.8 Heating in the transitional period

(spring/autumn)

During the transitional months, that is to say when

the outside temperatures are higher, sudden rises in

temperature can cause the ﬂue liner to ﬂuctuate, with the

result that heating gases are not fully drawn up. In this case,

fully open the “combustion air” lever (position 1) and ﬁll the

ﬁreplace insert with smaller quantities of small logs. The

fuel will then burn more quickly with ﬂames and will then

stabilise the ﬂue liner.

5.9 Operational breaks

Keep the door and all adjustment devices closed when the

ﬁreplace insert is not in operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Camina-Schmid Lina Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Camina-Schmid Lina

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info