4
1. Cut the tip of the supplied cartouche special glue "Spezialkleber 3" (pls wear the supplied Latex gloves!).
2. Apply evenly the glue onto the antenna feet (thickness of glue layer appr. 3 to 4mm)
3. Pls put the antenna (max. 5 minutes after applying the glue!) on the selected mounting place on the car
roof. Press the antenna feet smoothly ontot the roof and fix the antenna with tape e.g. to avoid moving.
After pressing the antenna feet onto the roof the minimum thickness of the glue layer must be appr.
2mm.
Now the glue needs a hardening time of appr. 48 hours (air humidity of 50%).
If the air humidity is lower than 50% pls spray some water into the air in the surrounding of the antenna
feet.
4. Remove the outcropped glue on the sides of antenna feet and clean the surface with the supplied fleece
and special cleaning fluid "Reiniger1".
5. In addition you can fix the antenna feet with the help of 4 screws. Pls set the screw after hardening of the
glue.
Sticking the antenna to your vehicle's roof:
Do not mount the Control box and your satellite receiver in the area of the vehicle's airbags!
Lay the cables carefully to avoid short circuit! Pay attention to existing cables!
1. Connect the antenna by plugging the long white cable into antenna and control box.
2. Put the gel cap over the antenna socket.
3. Connect the power cable (red/black) to the control box and power source (car battery e.g.).
Positive terminal (+) = red colour
Negative terminal (-) = black colour
Gel cap
Control box (rearview)
Power socket
3. Connections
Antenna socket (F)Receiver socket
