Bedienungsanleitung Campingaz Adelaide Woody 2 (Seite 8 von 93) (Alle Sprachen)

662239

Zoom out

Zoom in

Vorherige Seite

1/93

Nächste Seite

Belgium, Luxembourg, United Kingdom, Ireland,

Portugal, Spain, Italy, Croatia, Greece, Netherlands,

Czech Republic, Slovakia, Hungary, Slovenia, Norway,

Sweden, Denmark, Finland, Bulgaria, Turkey, Romania,

Poland:

The barbecue is equipped with a circular connector. It

should be used with flexible hose that is suitable for use with

butane and propane gas. Hose length should not exceed

1.20 metre. It should be replaced if it is damaged or

cracked, when required by national regulations or at the

end of the part lifecycle. Do not pull or pierce the hose.

Keep away from any parts of the barbecue that get hot.

Check that the flexible hose stretches out normally,

without twisting or pulling.

Switzerland, Germany, Austria:

The barbecue should be used with flexible tubing that is

suitable for use with butane and propane gas. Hose

length should not exceed 1.50 metre. It should be

replaced if it is damaged or cracked, when required by

national regulations or at the end of the part lifecycle. Do

not pull or pierce the tubing. Keep away from any parts of

the barbecue that get hot. Check that the flexible hose

stretches out normally, without twisting or pulling.

Flexible tubing connection: to connect the tubing to the

connector on the barbecue, tighten the nut on the tubing

firmly but without excess force using the two wrenches

provided:

- no. 14 wrench to tighten the connector

- no. 17 wrench to tighten the nut on the tubing

e) LID (DEPENDING ON MODEL)

Handle the lid carefully, especially during operation. Do not

lean over the base.

f)CHECKING FOR GAS LEAKS

1) Work outside, away from all sources of ignition. Do not

smoke.

2) Make sure the control knobs are in the "off" (l) position.

Connect the flexible tubing to the connector and

barbecue as described in part d).

4) Fit the regulator onto the gas cylinder in accordance with

its instructions.

5) Use a gas leak solution to test for leaks. Important: never

use a naked flame to check for gas leaks.

6) Apply the solution to the connections cylinder/regulator/

hose/apparatus (the control knobs should remain closed:

off position (l)). Open the gas cylinder valve.

7) Bubbles in the gas leak solution indicate that there are gas

leaks.

8) The leak can be stopped by tightening any hose

connection or replacing any faulty component. The

barbecue must not be used until the leak is stopped.

9) Close the valve on the gas cylinder.

Important:

Check for leaks at least once per year and each time the gas

cylinder is replaced.

g) PRIOR TO USE

Never use the barbecue until the instructions have been read

carefully and understood. Also, make certain that:

- there are no leaks

- the venturi tubes are not blocked (example: spider webs)

- the hose does not touch any components which may get

hot.

- that the ventilation openings in the gas receptacle housing

are not obstructed, if appropriate.

- that the drippings tray has been properly inserted in the

tray housing and that it has been pushed all the way

back until it will not go in any further.

Check that the venturi tubes (VT) cover the

injectors (IJ).

h) LIGHTING THE BARBECUE BURNERS

- Remove the protective cover or open the cooking area

lid (depending on model).

- Make sure that the control knobs are in the "OFF"

position (l).

- Push an adjustment button down and turn it anti-

clockwise until it is in the full flow position

( ), then

immediately press the ignition button down ( ) until you

hear a click. Repeat 3 or 4 times if necessary.

- Repeat this operation until the burner lights.

- If the burner does not ignite after 4 or 5 attempts, wait 5

minutes and then repeat the operation.

Once the burner is lit, there are two ways of lighting

another burner:

r Firstly, repeat the lighting operation described above;

r Secondly, light the burner to the right or left of the first

burner lit, then the other burners in turn by turning the

adjustment button to the full flow position

( ).

If the piezoelectric ignition does not function, light the burners

manually (next paragraph).

i) LIGHTING THE BARBECUE MANUALLY

- Remove the protective cover or open the cooking area

lid (depending on model).

- Make sure that the control knobs are in the "OFF"

position (l).

- Remove the grease drip tray.

- Strike a match and bring it close to the burner from

below.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Campingaz Adelaide Woody 2 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info