Bedienungsanleitung Campingaz Fargo (Seite 10 von 92) (Alle Sprachen)

662467

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

2) Open the gas cylinder valve.

3) Press the control knob and turn it to the full flame

( ) position, then immediately press the igniter

button ( ) until you hear the click. Repeat 3 or 4

times if necessary until the burner is lit.

4) If the burner fails to light, turn the control knob to the

"off" position (O). Wait 5 minutes before repeating the

operation.

Important:

If the burner fails to light after the 2

attempt, turn the

control knob to the "off" position (O) and check that the

burner outlets and the venturi tube are not blocked.

i) Lighting manually the burner

If Piezo ignition does not work, put the adjustment lever

in the "OFF" (O) position. Remove the drippings tray

located under the vat. Hold a lighted match to the

opening located under the burner, then open the lever on

the control panel to full-flow position ( ). Reposition the

drippings tray.

j) Turning off the grill burner

Return the control knobs to the "off" position (O), then

close the cylinder valve.

k) Operation

1. It's recommended that protective gloves be worn to

handle components which may be very hot.

2. Before start-up, put the feet in place (see paragraph c),

then open the fold-down shelves:

r Unfold the two shelf-support wires.

r Open the shelves until they are resting on the shelf-

support wires.

Flexible tubing connection: To connect the tubing to the

connector on the barbecue, tighten the nut on the tubing

firmly but without excess force using the two wrenches

provided:

- no. 11 wrench to tighten the connector

- no. 17 wrench to tighten the nut on the tubing

f) Checking for gas leaks

1) Work outside, away from all sources of ignition. Do not

smoke.

2) Make sure the control knob is in the "off" (O) position.

3) Push the end of the hose completely onto the regulator

nozzle and secure with a suitable clip.

4) Fit the regulator onto the gas cylinder in accordance

with its instructions.

5) Use a gas leak solution to test for leaks. Important:

never use a naked flame to check for gas leaks.

6) Apply the solution to the connections cylinder/regulator/

hose/apparatus (the control knobs should remain

closed: off position). Open the gas cylinder valve.

7) Bubbles in the gas leak solution indicate that there are

gas leaks.

8) The leak can be stopped by tightening any hose

connection or replacing any faulty component. The

barbecue must not be used until the leak is stopped.

9) Close the valve on the gas cylinder. Check for leaks at

least once per year and each time the gas cylinder is

replaced.

g) Prior to use

Never use the barbecue until the instructions have been

read carefully and understood. Also, make certain that:

- there are no leaks

- the venturi tubes are not blocked

- the hose does not touch any components which may get hot.

- that the feet are unfold (see paragraph K) 2.).

h) Lighting the burner

Read steps 1 to 5 before beginning with step 1.

1) Make sure the control knob is in the "off" (O) position.

Fargo

burner tube

burner outlets

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Campingaz Fargo Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info