Bedienungsanleitung Campingaz Master Plancha L (Seite 9 von 88) (Alle Sprachen)

662329

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

lid by sliding it sideways. Insert the batteries making sure the

positive and negative ends are facing the correct direction as

shown, then replace the lid. (see Fig. 12)

You can illuminate each of the control knobs on the control

panel independently.

1. Select a control knob and perform the ignition action (step

#3 in section H), when the burner is lit, control knob will be

illuminated. So you can tell which burner is working.

2. The control knob will remain illuminated until you you set it

to the STOP (O) position.

D. GAS CYLINDER

This appliance has been adjusted to operate from 4.5 to 15kg

butane/propane cylinders with an appropriate low pressure

regulator :

 Switzerland: see separate spreadsheet.

 France, Belgium, Luxembourg, United Kingdom,

Ireland, Portugal, Spain, Italy, Greece:

butane 28-30 mbar / propane 37 mbar.

 Netherlands, Norway, Sweden, Denmark, Finland,

Czech Republic, Slovenia, Slovakia, Hungary, Romania,

Estonia, Turkey, Bulgaria, Croatia: butane 30 mbar /

propane 30 mbar.

 Germany, Austria : butane 50 mbar / propane 50 mbar.

 Poland: propane 37 mbar.

Always connect or replace the cylinder in a well-ventilated

area, never in the presence of a flame, spark or heat source.

Regardless of the height H, the width or diameter D of the

cylinder, see Fig. 1.

E. HOSE

France: The equipment may be used with two types of

flexible hose: (Depending on the model)

a. flexible hose designed to be joined onto ringed tailpieces on

both the barbecue and regulator sides, held firm with collars

(in accordance with standard XP D 36-110). Recommended

length 1.25 metre. (Fig. 2-A)

b. flexible hose (according to standard XP D 36-112 or NF

D 36-112) fitted with a G 1/2 threaded nut for fixing to the

barbecue and a M 20x1.5 threaded nut for fixing to the

regulator, recommended length 1.25 metre. (Fig. 2-B)

The barbecue has a G 1/2 threaded gas inlet connector

supplied with pre-fitted NF ringed tailpiece and seal.

1. To use the appliance with the flexible hose XP D 36-110

(Fig. 2-A):

y slide the flexible hose onto the ringed tailpiece on both

the barbecue and regulator as far as it will go.

y slide the collars behind the two first bosses on the

tailpieces and tighten them until the tightening head

breaks.

y check for leaks following the instructions in paragraph P).

2. To use the equipment with the flexible hose XP D 36-112

y Please read the instructions carefully before use.

y Use outdoors only.

y Do not use charcoal.

y Do not use an adjustable low pressure regulator. Only use fixed regulators that comply with relevant European

Standards.

y Regularly clean the parts at the frame bottom to avoid risk of inflammation from fat drippings.

Follow these instructions carefully to avoid serious damage to your barbecue.

INSTRUCTIONS FOR USE

A. FOR YOUR SAFETY

y Do not store or use petrol and other flammable liquids or

vapours in the vicinity of this appliance. This device must

be kept away from inflammable materials when it is in use.

If you smell gas:

1. Close the valve of the cylinder.

2. Extinguish all naked flames.

3. If the smell continues, see “F. Checking for gas leaks” or

immediately seek advice from your local retailer.

y Do not leave your appliance unattended while it is working.

y Parts which are protected by the manufacturer or the

manufacturer’s representative must not be manipulated by

the user.

y Close the gas container after use.

B. LOCATION

y This appliance must be used outdoors.

y CAUTION : accessible parts may get very hot. Keep young

children away.

y There should be no combustible materials within a radius of

approximately 1 meter around the appliance.

y Do not move the appliance when alight.

y install your appliance and the gas bottle on a flat, level and

non-inflammable surface. If you are using your appliance on

grass, please pay attention that it is not too high and that it

cannot reach the flame to avoid any risks of fire.

y Use the appliance on a stable support and strong enough to

carry the appliance weight (table), flat and horizontal, put the

gas bottle directly on the floor.

y Regardless of the height H, the width or diameter D of the

cylinder, see Fig. 1.

y The gas bottle must be installed at least 30cm away from the

appliance, see Fig. 1.

y Estimated air offtake is 2 m

/kW/h.

INSTALLATION OF BATTERIES FOR AUTOMATIC

LIGHTING L LIGHTING AND CONSOLE

ILLUMINATION (DEPENDING ON THE MODEL)

ELECTRONIC IGNITION OF GAS BURNERS :

y The system for automatic lighting of the gas burners is

y The battery holder is located under the console (Fig. 10).

y See fig. 11 for battery installation:

1) Unscrew the top of the lighting battery holder “A”.

2) Insert the AA battery making sure the positive and negative

ends are facing the correct direction as shown (Fig. 11),

then screw the top back in place.

The console illumination system is powered by four AA (LR06)

type batteries. The battery holder is located at the bottom front

area of the appliance (see Fig. 10). Remove the battery holder

NOTE: Unless otherwise specified, following generic terms “appliance / unit / product / equipment / device” appeared in this

instruction manual all refer to the product “Plancha”.

Campingaz Master Plancha L Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info