Bedienungsanleitung Camry CR 4415 (Seite 4 von 108) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

801594

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

17. To provide additional protection, it is advisable to install a residual

current device (RCD) in the electric circuit with a rated residual current not

exceeding 30 mA. Ask an electrician for this advice.

18. Never use the device without water! It may be damaged.

19. Never use the device with sparkling water !!!

20. Never leave the device at a temperature below 0 degrees Celsius, as it

may damage it.

21. Always unplug the machine before filling the tank with water.

22. Regularly clean and inspect the machine to ensure the quality of coffee

obtained and to extend the life of the machine.

24. For descaling the machine, use a liquid descaler designed for pressure

coffee makers.

23. Always disconnect the power source before cleaning and allow all hot

parts to cool down. The device should be cleaned with a mild non-abrasive

detergent. Never use cleaning solvent as this could damage the paint

layer.

25. Use only original accessories.

26. Do not move or move the device during operation.

Device description Moka maker:

A. Lid B. Top tank C. Bottom tank D. Base E. Power cord F. On / Off switch G. Light

indicator H. Safety Valve I. Funnel filter J. Disc Filter K. Gasket for upper disk

filter L. Upper Disk Filter

Preparing the device for use.

1. Remove all packing material from the device.

2. Rinse the inside of the Top tank (B) and Bottom tank (C) with water making sure the water does not overflow.

3. Use a dry paper towel to dry the device both inside and outside making sure the area between the Base (D) and the Bottom tank (C )

is dry.

Never immerse the base and the boiler in the water while cleaning.

Please note this device is for making coffee. Do not use any other extracts, cocoa powder, herbs, flowers, sugars, infusions soluble

substances, or other substances that might block the holes in the device filters.

Using the device:

1. Check if the device is not hot from previous use.

3. Grasp the Bottom tank (C ) with your other hand.

2. Grasp the Top tank (B) with a dry hand and do not press or pull on the handle.

4. Twist the Top tank (B) counterclockwise until you unscrew the Top tank (B) from the Bottom tank (C ) making sure not to press or pull

on the handle.

5. Once you open the device take out the Disk Filter (J) and the Funnel filter (I).

6. Fill the Bottom tank (C ) with water. The water level should not reach the Safety Valve (H).

7. Insert the Funnel filter (I) into the bottom tank.

8. Fill the Funnel filter (I) with ground coffee to around 4/5 of its capacity.

10. Screw the Top tank (B) back on top of the Bottom tank (C). Make sure not to press or pull on the handle.

9. Put the Disk Filter (J) with the little button facing upward. The Disk filter is designed to keep the coffee ground in the Funnel filter. If not

used small parts of the coffee ground can end up in the finished coffee brew.

12. Press the ON / OFF button (F). The Light indicator (G) will turn on.

11. Put the assembled device onto the Base (D).

13. The Moka maker will start brewing.

14. After some time the Moka maker will start to bubble and prepare the coffee.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Camry CR 4415 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info