Bedienungsanleitung Canadian Spa Company Thunder Bay SE - KH-10030 (Seite 23 von 24) (Englisch)

764897

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

THUNDER BAY SE

System-Related Messages

Memory Failure - Checksum Error* – M022

At Power-Up, the system has failed the Program Checksum

Test. This indicates a problem with the rmware (operation

program) and requires a service call.

Conguration Error – Spa will not Start Up

Contact your dealer or service organisation.

A Pump Appears to be Stuck ON – M034

Water may be overheated. POWER DOWN THE SPA. DO NOT

ENTER THE WATER. Contact your dealer or service organization.

A Pump Appears to have been Stuck ON when spa was last

powered – M035

POWER DOWN THE SPA. DO NOT ENTER THE WATER.

Contact your dealer or service organization.

Reminder Messages

General maintenance helps.

Reminder Messages can be suppressed by using the PREF

Menu. Reminder Messages can be chosen individually by the

Manufacturer. They may be disabled entirely, or there may be a

limited number of reminders on a specic model.

The frequency of each reminder (i.e. 7 days) can be specied

by the Manufacturer. Press Temperature Up button to reset a

displayed reminder message.

Appears on a regular schedule, e.g. every 7 days.

Check pH with a test kit and adjust pH with the appropriate

chemicals.

Appears on a regular schedule, e.g. every 7 days.

Check sanitizer level and other water chemistry with a test kit

and adjust with the appropriate chemicals.

Appears on a regular schedule, e.g. every 30 days.

Clean the lter media as instructed by the manufacturer.

Appears on a regular schedule, e.g. every 30 days.

The Residual Current Device (RCD) is an important safety

device and must be tested on a regular basis to verify its

reliability.

Every user should be trained to safely test the RCD

associated with the hot tub installation. An RCD will have a

TEST and RESET button on it that allows a user to verify proper

function.

Warning:

If freezing conditions exist, an RCD should be reset immedi-

ately or spa damage could result. The end user should always

trained to test and reset the RCD on a regular basis.

Appears on a regular schedule, e.g. every 90 days.

Change the water in the spa on regular basis to maintain

proper chemical balance and sanitary conditions.

Appears on a regular schedule, e.g. every 180 days.

Vinyl covers should be cleaned and conditioned for maximum

life.

Appears on a regular schedule, e.g. every 180 days.

Wood skirting and furniture should be cleaned and conditioned

per the manufacturers instructions for maximum life.

Appears on a regular schedule, e.g. every 365 days.

Filters should be replaced occasionally to maintain proper spa

function and sanitary conditions.

As needed.

Install new mineral cartridge.

Reminders

CHEK PH Check your PH levels (every 7 days)

CHEK CHEM Check your Chemical levels (every 7 days)

CLN FLTR Clean the Filters/replace Filters (every 30 days)

To reset the Reminders press TEMP-UP button until all

messages have been removed and

Spa Temp is displayed.

(23)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canadian Spa Company Thunder Bay SE - KH-10030 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info