Bedienungsanleitung Candy CCHE 155 (Seite 10 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

462447

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

If the appliance is provided with a condenser on the external wall fig.1 (S), periodically remove any dust and dirt from it, since these

prevent heat being vented from the appliance.

The formation of ice and frost on the inside walls has a detrimental effect on the appliance's ability to chill, and should therefore be

removed periodically. For removal of frost and ice, adhere strictly to the manufacturer's recommendations.

DEFROSTING

To carry out defrosting proceed as follows:

- turn the thermostat to 0; fig.2 (A)

- unplug the appliance or switch off the domestic power supply at the main switch;

- remove all food from the freezer;

- remove the defrost water drain plug inside the compartment and on the outside of the housing, where provided.; fig.1 (Z)

- place a container next to the external drain outlet to collect the defrost water;

- dry the inside walls.

With normal use (the appliance is opened 3-4 times a day) the freezer should be defrosted once or twice a year.

Never use electrical appliances such as hairdryers, fan heaters or a naked flame for defrosting.

AFTER-SALES SERVICE

Only contact after-sales service if you are unable to solve the problem yourself with the help of the “Troubleshooting

guide/Causes/Solutions” (supplied with the appliance).

To facilitate the job of the after-sales service, before calling take note of the following information to identify your appliance:

• Appliance brand;

• Model/Type;

• Type of problem;

• Date of purchase;

• Name of retailer;

TROUBLESHOOTING GUIDE/CAUSES/SOLUTIONS

Abnormal operation is not always caused by an actual malfunction of the appliance, but by incorrect installation or use. To avoid needless

call-outs and the relative bill for after-sales service, observe the following:

The appliance is not working

Check that:

The thermostat is not at 0.

The power plug is in good condition and properly inserted in the socket

There is no power cut.

The appliance does not freeze sufficiently

Freezing takes too long

The compressor runs too much

Check that:

The door is closed properly; fig.1 (A)

The thermostat is set to the correct position; fig.2 (A)

The freezer is not too near a heat source;

There is not an excessive build-up of frost in the low temperature compartment;

The appliance is too noisy

Check that:

The appliance is properly level;

The rear coil is not touching the wall; fig.1 (S)

Bear in mind that it is normal for the appliance to produce the following noises:

clicking noises caused by the compressor starting and stopping;

humming noises when the compressor begins running;

gurgling noises as the refrigerant gas flows through the pipelines, even once the compressor stops;

IMPORTANT!

The manufacturer declines all liability for injury to persons or animals and for damage to property resulting directly or indirectly

from failure to observe the procedures and reminders given in this instruction booklet.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Candy CCHE 155 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info