Bedienungsanleitung Candy CDIM 2312 (Seite 5 von 68) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

621254

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Programme operations

When a programme is running the relevant

indicator light will remain on and the 3

“PROGRAMME STATUS” indicator lights

("WASH" , "RINSE" , and "DRY" )

will light singularly and in sequence to

indicate the current phase.

If there is any break in the power supply

while the dishwasher is operating, a

special memory stores the selected

programme and, when the power is

restored, it continues where it left off.

Programme end

A 5 second alarm will sound (if not muted)

3 times at 30 second intervals to signal that

the programme has ended.

The selected programme indicator light (2

indicator lights for the "COLD RINSE"

programme) will start to flash.

Dishes can now be removed and the

dishwasher turned off by pressing the

"ON/OFF" button or dishes can be loaded

for new cycle.

Option button

"HPS" button

The "HPS" option always guarantees the

best results by more effectively dealing

with heavier soiling. By using this option,

the strength of the selected cycle will be

increased, adding one rinse and increasing

the temperature and water pressure in the

washing phase where foreseen.

This option is recommended for very dirty

dishes or when dirty dishes may not have

been pre-treated allowing the soiling to dry up.

IMPORTANT

With this option selected the “IMPULSE”

wash is turned off.

"DELAY START" button

The dishwasher start time can be set with

this button, delaying the start by 3, 6 or 9

hours.

Proceed as follows to set a delayed start:

■ Press the "DELAY START" button (each

time the button is pressed the start

will be delayed by 3, 6 or 9 hours

respectively and the corresponding time

indicator light will illuminate).

■ To start the countdown, press the selected

programme button (the relevant indicator

light will come on, while the set time

indicator light will start to flash).

If a 9 hour delay is set, countdown will be

displayed by the 6h indicator light after 3

hours and the 3h indicator light after 6

hours.

At the end of the last 3 hours (at the end

of countdown) the 3h indicator light will

stop flashing and remain on to indicate the

washing phase and the programme will

start automatically.

If countdown has not ended, whereby

the programme has not yet started, it is

possible to change or cancel the delayed

start and select another programme or to

select/deselect the option button, proceeding

as follows:

■ Hold down the selected programme

button for at least 5 seconds.The

programme indicator lights will turn on

and off individually and sequentially and

some audible signals will sound.

■ The delayed start and the selected

programme will be cancelled.

All the programme indicator lights will flash.

■ Press the "DELAY START" button to

set another delayed start time (the

corresponding indicator light will turn on).

■ A new programme can be set after a

delayed time has been changed or

cancelled or an option button has selected

or deselected.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Candy CDIM 2312 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info