Electricity supply and safety advice
Washing machines are supplied to operate at a voltage of 230V, 50 Hz single-phase. Check
that the conductor is powerful enough to supply at least 3.0 kW, then connect the plug to a 10A
earthed socket.
After installation,the appliance must be positioned so that the plug is accessible.
Check that the electricity supply to your home has an earthing system.
The socket in your home and the plug on the appliance must be of the same type.
It is generally not advisable to use multiple adapters and/or extension leads.
All Candy washing machines comply with the safety requirements laid down by the Quality
Trademark Institute.
71
Water supply
The machine has an inlet hose with 3/4» threaded
ferrules fitted to the ends to attach between the threaded
connector on the appliance and the cold water supply.
The appliance must be connected to the water mains
using new hose-sets. The old hose-sets should not be
reused.
The appliance must only be connected to the cold water
supply.
Connection to a warm water supply, that is over 40°, may
damage certain delicate fabrics.
Note: it is advisable to turn off the tap after each wash to
isolate the washing machine from the water supply.
If the inlet hose’s connection point is changed, check that the 3/4» threaded ferrule on the inlet
hose is firmly attached to the electrovalve connector.
For the washing machine to function properly the terminal end of the discharge hose
(mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the ground.
70
