Bedienungsanleitung Candy f 222 (Seite 9 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

329115

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Thank you for choosing one of our products. To get the most out of your oven we recommend that you:

• Read the notes in this manual carefully: they contain important instructions on how to install, use and service this oven safely.

• Keep this booklet in a safe place for easy, future reference.

When the oven is first switched on it may give out acrid smelling fumes. This is because the bonding agent for insulating panels around

the oven has been heated up for the first time.

This is a completely normal, if it does occur you merely have to wait for the fumes to clear before putting the food into the oven.

An oven by its very nature becomes very hot. Especially the glass of the oven door.

Do not allow children to go near the oven when it is hot, especially when the grill is on.

A specially designed protector shield (some models only) which reduces considerably the surface temperature of the oven door can

be obtained through our service organization. This shield is recommended for households with young children.

GENERAL WARNINGS

To locate the fixing holes, open the oven door and look inside.

To allow adequate ventilation, the measurements and distances

indicated in the diagram on last page must be adhered to when

fixing the oven.

Note: For ovens that are combined with a hob unit the instructions

contained in the manual for the hob unit must be followed.

IMPORTANT

If the oven is to work properly, the kitchen housing must be suitable.

The panels of the kitchen unit that are next to the oven must be

made of a heat resistant material. Ensure that the glues of units

made of veneered wood can withstand temperatures of at least

120 °C. Plastics or glues that cannot withstand such temperatures

will melt and deform the unit. Once the oven has been lodged

inside the unit, the electrical parts must be completely insulated.

This is a legal safety requirement. All guards must be firmly fixed

into place so that it is impossible to remove them without using

special tools.

Remove the back of the kitchen unit to ensure an adequate

current of air circulates around the oven. The hob must have

a rear gap of at least 45 mm.

CONNECTING TO THE POWER SUPPLY

Plug into the power supply. Ensure first that there is a third contact

that acts as earthing for the oven. The oven must be properly

earthed.

If the model of oven is not fitted with a plug, fit a standard plug

to the power cable. It must be able to bear the power supply

indicated on the specifications plate. The earthing cable is yellow-

green. The plug must be fitted by a properly qualified person.

If the socket and the plug are incompatible the socket must be

changed by a properly qualified person. A properly qualified person

must also ensure that the power cables can carry the current

required to operate the oven.

An ON/OFF switch with a minimum distance of 3 mm between

contacts may also be connected to the power supply. The

connections must take account of the current supplied and must

comply with current legal requirements. The yellow-green earthing

cable must not be governed by the ON/OFF switch. The socket

or the ON/OFF switch used for connecting to the power supply

must be easily accessible when the oven has been installed.

Important: During installation, position the power cable in such a

way that it will not be subjected to temperatures of above 50°C

at any point.

The oven complies with safety standards set by the regulatory

bodies. The oven is safe to use only if it has been adequately

earthed in compliance with current legal requirements on wiring

safety. You must ensure that the oven has been adequately

earthed.

The manufacturers cannot be held responsible for any harm

or injury to persons, animals or belongings caused by failure

to properly earth the oven.

WARNING: the voltage and the supply frequency are showed

on the rating plate (fig. on last page).

The cabling and wiring system must be able to bear the maximum

electric power required by the oven. This is indicated on the

specifications plate.

If you are in any doubt at all, use the services of a professionally

qualified person.

DECLARATION OF COMPLIANCE

• The parts of this appliance that may come into contact with

foodstuffs comply with the provisions of EEC Directive 89/109.

This appliances complies with Directives 89/336/EEC,

73/23/EEC and following changes.

When you have unpacked the oven, make sure that it has not

been damaged in any way. If you have any doubts at all, do

not use it: contact a professionally qualified person.

Keep packing materials such as plastic bags, polystyrene, or

nails out of the reach of children because they are dangerous

for children.

SAFETY HINTS

The oven must be used only for the purpose for which it was

designed: it must only be used for cooking food.

Any other use, e.g. as a form of heating, is an improper use

of the oven and is therefore dangerous.

The manufacturers cannot be held responsible for any damage

caused by improper, incorrect or unreasonable use.

When using any electrical appliance you must follow a

few basic rules.

– Do not pull on the power cable to remove the plug from the

socket.

– Do not touch the oven with wet or damp hands or feet.

– Do not use the oven unless you are wearing something on

your feet.

– Do not allow children or irresponsible people to use the oven

unless they are carefully supervised.

– It is not generally a good idea to use adapters, multiple sockets

for several plugs and cable extensions.

– If the oven breaks down or develops a fault switch it off at the

mains and do not touch it.

If the cable is at all damaged it must be replaced promptly.

When replacing the cable, follow these instructions.

Remove the power cable and replace it with one of the HO5RR-

F, H05VV-F, H05V2V2-F type. The cable must be able to bear

the electrical current required by the oven. Cable replacement

must be carried out by properly qualified technicians.

The earthing cable (yellow-green) must be 10 mm longer than

the power cable.

Use only an approved service centre for repairs and ensure

that only original parts are used. If the above instructions are

not adhered to the manufacturers cannot guarantee the safety

of the oven.

INSTALLATION

Installation is the customer’s responsibility. The manufacturers

have no obligation to carry this out. If the assistance of the

manufacturer is required to rectify faults arising from incorrect

installation, this assistance is not covered by the guarantee.

The installation instructions for professionally qualified personnel

must be followed. Incorrect installation may cause harm or injury

to people, animals or belongings. The manufacturer cannot be

held responsible for such harm or injury.

FITTING THE OVEN INTO THE KITCHEN UNIT

Fit the oven into the space provided in the kitchen unit; it may be

fitted underneath a work top or into an upright cupboard.

Fix the oven in position by screwing into place, using the four

fixing holes in the frame.

8 GB

Candy f 222 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info