Bedienungsanleitung Candy FLE0502 (Seite 13 von 100) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch)

703586

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

Plug into the power supply. Ensure first that there is a third contact that

acts as earthing for the oven.

If the model of oven is not fitted with a plug, fit a standard plug to the

power cable. It must be able to bear the power supply indicated on the

specifications plate. The earthing cable is yellowgreen. The plug must

be fitted by a properly qualified person. If the socket and the plug are

incompatible the socket must be changed by a properly qualified

person.A properly qualified person must also ensure that the power

cables can carry the current required to operate the oven.

An ON/OFF switch may also be connected to the power supply. The

connections must take account of the current supplied and must comply

with current legal requirements. The yellow-green earthing cable must

not be governed by the ON/OFF switch. The socket or the ON/OFF

switch used for connecting to the power supply must be easily

accessible when the oven has been installed.

The oven must be properly earthed.

1.6 CONNECTING TO THE POWER SUPPLY

13 GB

1.2 SAFETY HINTS

•The oven must be used only for the purpose for which it was designed:

it must only be used for cooking food. Any other use, e.g. as a form of

heating, is an improper use of the oven and is therefore dangerous.

•The manufacturers cannot be held responsible for any damage caused

by improper, incorrect or unreasonable use.

– Do not pull on the power cable to remove the plug from the socket.

– Do not touch the oven with wet or damp hands or feet.

– Do not use the oven unless you are wearing something on your feet.

– It is not generally a good idea to use adapters, multiple sockets for

several plugs and cable extensions.

– If the oven breaks down or develops a fault switch it off at the mains

and do not touch it.

•If the cable is at all damaged it must be replaced promptly.

When replacing the cable, follow these instructions. Remove the power

cable and replace it with one of the H05RRF, H05VV-F, H05V2V2-F

type. The cable must be able to bear the electrical current required by

the oven. Cable replacement must be carried out by properly qualified

technicians. The earthing cable (yellow-green) must be 10 mm longer

than the power cable.

Use only an approved service centre for repairs and ensure that only

original parts are used. If the above instructions are not adhered to the

manufacturers cannot guarantee the safety of the oven.

•Do not line the oven walls with aluminium foil or single-use

protection available from stores. Aluminium foil or any other

protection, in direct contact with the hot enamel, risks melting and

deteriorating the enamel of the insides.

When using any

electrical appliance you must follow a few basic rules.

1.3 INSTALLATION

Installation is the customer’s responsibility. The manufacturers have no

obligation to carry this out. If the assistance of the manufacturer is

required to rectify faults arising from incorrect installation, this

assistance is not covered by the guarantee.

The installation instructions for professionally qualified personal must

be followed. Incorrect installation may cause harm or injury to people,

animals or belongings. The manufacturer cannot be held responsible

for such harm or injury.

If the oven is to work properly, the kitchen housing must be suitable. The

panels of the kitchen unit that are next to the oven must be made of a

heat resistant material. Ensure that the glues of units made of veneered

wood can withstand temperatures of at least 120 °C. Plastics or glues

that cannot withstand such temperatures will melt and deform the unit.

Once the oven has been lodged inside the unit, the electrical parts must

be completely insulated. This is a legal safety requirement. All guards

must be firmly fixed into place so that it is impossible to remove them

without using special tools.

Remove the back of the kitchen unit to ensure an adequate current

of air circulates around the oven. The hob must have a rear gap of

at least 45 mm.

It is necessary to do an initial cleaning of the equipment before the

first use of each of them.Wash them with a sponge. Rinse and dry

off.

1.7 OVEN EQUIPMENT (according to the model)

1.4 FITTING THE OVEN INTO THE KITCHEN UNIT

Fit the oven into the space provided in the kitchen unit; it may be fitted

underneath a work top or into an upright cupboard. Fix the oven in

position by screwing into place, using the four fixing holes in the frame.

(Fig.on last page).

To locate the fixing holes, open the oven door and look inside.To allow

adequate ventilation, the measurements and distances indicated in the

diagram on last page must be adhered to when fixing the oven.

For ovens that are combined with a hob unit the instructions

contained in the manual for the hob unit must be followed.

Note:

1.5 IMPORTANT

The simple shelf

The tray holder shelf

can take moulds and

dishes.

is especially

good for grilling things. Use it with the

drip tray.

The special profile of the shelves

means they stay horizontal even when

pulled right out. There is no risk of a dish

sliding or spilling.

The drip tray catches the juices from

grilled foods. It is only used with the Grill,

Rotisserie, or Fan Assisted Grill ; remove

it from the oven for other cooking

methods.

Never use the drip tray as a roasting tray as this creates smoke and fat

will spatter your oven making it dirty.

The pizza set is designed for pizza cooking.

In order to obtain the best results the set

must be used together with Pizza function.

The tray holder

The tray holder shelf is ideal for grilling. Use it in

conjunction with the drip tray. A handle is

included to assist in moving the both

accessories safely. Do no leave the

handle inside the oven.

Important: During installation, position the power cable in such a way

that it will not be subjected to temperatures of above 50°C at any point.

The oven complies with safety standards set by the regulatory bodies.

The oven is safe to use only if it has been adequately earthed in

compliance with current legal requirements on wiring safety. You must

ensure that the oven has been adequately earthed.

The manufacturers cannot be held responsible for any harm or

injury to persons, animals or belongings caused by failure to

properly earth the oven.

WARNING: the voltage and the supply frequency are showed on

the rating plate (fig. on last page).

The cabling and wiring system must be able to bear the maximum

electric power required by the oven. This is indicated on the

specifications plate. If you are in any doubt at all, use the services of a

professionally qualified person.

1- Remove the knurled nuts by turning them counter clockwise.

2- Remove the wire racks by pulling them towards yourself.

3- To clean the wire racks either put them in the dishwasher or use

a wet sponge, ensuring that they are dried afterwards.

4- After the cleaning process install the wire racks in reverse order.

5- Replace the knurled nuts.

Removing and cleaning wire racks

Candy FLE0502 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info